DEFSTAN 05-61(PT12)/1(1987) : 1987
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
QUALITY ASSURANCE PROCEDURAL REQUIREMENTS - PART 12: CONTROL OF WALL THICKNESS IN DESIGN AND MANUFACTURE OF FLYING CONTROL SYSTEMS
Hardcopy , PDF
02-11-2015
English
01-01-1987
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Preface
0 Introduction
1 Scope
2 Health and Safety Warning
3 Definitions
4 Requirements
5 Verification Methods
6 Implementation by the Manufacturing Contractor
Describes quality/inspection control of wall thickness of bored, counterbored, drilled or other hollow parts in flying control systems
| DevelopmentNote |
Supersedes QTR 1/AQD & QTM 15 (07/2003) This standard is obsolescent because it is no longer required for the procurement of new equipment but is retained for maintenance purposes in support of existing in-service equipment. (09/2007)
|
| DocumentType |
Standard
|
| Pages |
2
|
| PublisherName |
UK Ministry of Defence Standards
|
| Status |
Withdrawn
|
| DEFSTAN 00-970(PT7)SEC7/1(2006) : 2006 | DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 7: ROTORCRAFT - SECTION 7: INSTALLATIONS |
| DEFSTAN 00-970(PT7)SEC2/SUPP4/5(2015) : INTERIM | DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 7: ROTORCRAFT - SUPPLEMENT 4: DESIGN AND CONSTRUCTION (SUBPART D) |
| DEFSTAN 00-970(PT7)SEC2/SUPP4/6(2015) : 2015 | DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 7: ROTORCRAFT - SUPPLEMENT 4: DESIGN AND CONSTRUCTION (SUBPART D) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.