DEFSTAN 59-41(PT5)/2(1998) : 1998

Preface
0 Introduction
1 Scope
2 Warning
3 Safety Considerations when using Pulse Generators
4 Generators and Calibration Jigs
5 Transient Generator Performance Specifications
6 Injection Probe Performance Specifications
7 Calibration Jigs
8 Monitor Loops and Voltage Probes
9 Average Detector - Test methods DRE01 and DRE03
10 Line Impedance Stabilizing Network (LISN)
11 Method for Damping Screened Room
12 Screened Room Damping Performance Verification Procedure
13 Voltage probes - Test Method DCE03 (Supplement C) and
   DCS01 (Supplement G)
Tables
1 Generator and Calibration Jig Combination by Test Title
2 Output Current against Frequency for Type 1N Generator
3 Pulse Waveform and Output Characteristics
4 ESD Generator Output Requirements
5 Outline Technical Characteristics of ESD Generator
6A Performance Specifications for CW Injection Probes
6B Performance Specifications for Transient Injection Probes
7 Jig Input and Transfer Impedance Requirements
8 Antennas required for each frequency band
Figures
1 Typical Type 1 Transient Waveform
2 Typical Type 2 Transient Waveform
3 Typical Type 3 Waveforms
4 Typical Type 4 ESD Output Current Waveform
5 Simplified Circuit of the ESD Generator
6 ESD Generator Discharge Tip Geometry
7 ESD Calibration Arrangement
8 Monitor Loop Probe for Test DCS04
9 Voltage Probes, 20 Hz - 10 MHz for Test DCE01 (Part 4)
10 Limits for Low Frequency Impedance/Frequency Characteristics
   of LISN
11 Limits for High Frequency Impedance/Frequency Characteristics
   of LISN
12 Circuit Diagram of Typical LISN
13 Modification to DC Supplies to limit surge currents
14 Arrangement of first two rows and columns of ferrite tiles
15 Intermediate stage of ferrite tile replacement
16 Placement of ferrite tiles to suppress low frequency
   reflections on walls
17 Placement of ferrite tiles to suppress low frequency
   reflections of floors and ceilings
18 Typical plan of carbon loaded foam cone layout
19 Theoretical normalized site insertion loss
20 Antenna positions for band 1, 86cm Dipole and Biconical
21 Antenna positions for band 2, 16cm Dipole and Biconical
22 Antenna positions for band 3, 16cm Dipole and Log Periodic
23 Antenna positions for bands 2&3, 16cm Dipole and Bilog
24 Cable layout diagram
25 Basic Circuit for Probe/Filter/Oscilloscope Layout

Gives performance specification for specialised EMC test equipment.