DIN 17862:1993-02

1 Scope and field of application
2 Designation and ordering
      2.1 Standard designation
      2.2 Essential order details
      2.3 Optional order details
3 Requirements
      3.1 Manufacturing process
      3.2 Chemical composition
             3.2.1 Ladle analysis
             3.2.2 Product analysis
             3.2.3 Permissible deviations
      3.3 Mechanical properties
      3.4 Additional information
      3.5 Tolerances
             3.5.1 Tolerance on thickness
             3.5.2 Out-of-roundness
             3.5.3 Deviations in form
             3.5.4 Tolerance on length
             3.5.5 Tolerance on straightness
      3.6 Form of bar ends and appearance
             3.6.1 Form of bar ends
             3.6.2 Appearance
4 Testing
      4.1 Inspection documents
             4.1.1 Test report
             4.1.2 Inspection certificates and inspection
                      report
      4.2 Scope of testing
             4.2.1 Chemical composition
             4.2.2 Tensile test
             4.2.3 Check of dimensional accuracy
             4.2.4 Check of appearance
             4.2.5 Additional tests
      4.3 Sampling
      4.4 Test procedures
             4.4.1 Chemical composition
             4.4.2 Tensile test
             4.4.3 Determination of notch impact strength
             4.4.4 Hardness test
             4.4.5 Non-destructive testing
             4.4.6 Determination of grain size
             4.4.7 Acceptance inspection
             4.4.8 Corrective action
             4.4.9 Retests
      4.5 Invalid test results
5 Marking
6 Packaging
Standards and other documents referred to

Specifies technical delivery conditions for bars made from titanium and titanium alloy ('titanium', for short). It applies to round, square, hexagon, octagon and flat bars with a width-to-thickness ratio not exceeding 8:1 in the case of unalloyed and low alloy width-to-thickness ratio not exceeding 8:1 in the case of unalloyed and low alloy titanium, and 3:1 in the case of high alloy titanium.