• Shopping Cart
    There are no items in your cart

DIN 7157:1966-01

Withdrawn

Withdrawn

A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.

RECOMMENDED SELECTION OF FITS; TOLERANCE ZONES; ALLOWANCES, FIT TOLERANCES

Available format(s)

Hardcopy , PDF

Withdrawn date

01-06-2014

Language(s)

English

Published date

01-01-1966

The ISO Recommendations ISO/R 286 - 1962 contains a large number of tolerance zones in common use. These tolerance zones were taken over, with certain curtailments and additions, into DIN 7160, ISO allowances for external dimensions (shafts) for nominal sizes from 1 to 500 mm and into DIN 7161, ISO allowances for internal dimensions (holes) for nominal sizes from 1 to 500 mm. The unlimited combining of these tolerances zones would give rise to a very large number of fits. Economic manufacture, however, demands drastic limitation of the number of tolerance zones the combinations of which lead to universally applicable and recommended fits.

DocumentType
Standard
Pages
6
PublisherName
German Institute for Standardisation (Deutsches Institut für Normung)
Status
Withdrawn

DIN 7155-2:1966-08 ISO-FITS FOR THE SHAFT BASIS SYSTEM; TOLERANCES OF FIT (CLEARANCES AND INTERFERENCES)
DIN 7155-1:1966-08 ISO-FITS FOR THE SHAFT BASIS SYSTEM; TOLERANCE ZONES, DEVIATIONS
DIN 7154-1:1966-08 ISO-FITS FOR THE HOLE BASIS SYSTEM; TOLERANCE ZONES, DEVIATIONS
DIN 7154-2:1966-08 ISO-FITS FOR THE HOLE BASIC SYSTEM; TOLERANCES OF FIT (CLEARANCES AND INTERFERENCES)

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.