DIN EN 12341:1999-03
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
AMBIENT AIR - STANDARD GRAVIMETRIC MEASUREMENT METHOD FOR THE DETERMINATION OF THE PM[10] OR PM[2],[5] MASS CONCENTRATION OF SUSPENDED PARTICULATE MATTER
Hardcopy , PDF
07-03-2021
English
01-01-1999
Important note : Users cannot be edited or removed once added to your Multi user PDF.
National foreword
National Annex NA (informative) - Bibliography
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
4 Principle
5 Equipment and facilities
6 Filter conditioning, sampling and weighing
procedures
7 Ongoing quality control
8 Expression of results
9 Performance characteristics of the method
Annex A (normative) - Design drawing of standard
inlet for the sampling of PM[10] and PM[2],[5]
Annex B (normative) - Other samplers
Annex C (informative) - Scheme of PM standard sampler
Annex D (informative) - Suitability tests for filters
Annex E (normative) - Initial suitability testing of
weighing facilities
Annex F (informative) - Results of experimental work
Annex G (informative) - Impactor efficiency
Bibliography
Defines a standard method for determining the PM[10] or PM[2],[5] mass concentrations of suspended particulate matter in ambient air by sampling the particulate matter on filters and weighing them by means of a balance.
| DevelopmentNote |
Supersedes DIN EN 14907 E. (08/2014)
|
| DocumentType |
Standard
|
| Pages |
26
|
| PublisherName |
German Institute for Standardisation (Deutsches Institut für Normung)
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| ONORM EN 12341 : 2014 | Identical |
| EN 12341:2014 | Identical |
| NS EN 12341 : 2014 | Identical |
| NEN EN 12341 : 2014 | Identical |
| NF EN 12341 : 2014 | Identical |
| BS EN 12341:2014 | Identical |
| NBN EN 12341 : 2014 | Identical |
| SN EN 12341:2014 | Identical |
| I.S. EN 12341:2014 | Identical |
| UNI EN 12341 : 2014 | Identical |
| UNE-EN 12341:2015 | Identical |
| VDI 2268 Blatt 3:1988-12 | Chemical analysis of particulate matter; determination of thallium in particulate emissions by atomic absorption spectrometry |
| ISO/IEC 17025:2005 | General requirements for the competence of testing and calibration laboratories |
| EN 13274-7:2008 | Respiratory protective devices - Methods of test - Part 7: Determination of particle filter penetration |
| VDI 2267 Blatt 12:2008-10 | Determination of suspended matter in ambient air - Measurement of As, Ca, Cd, Co, Cr, Cu, Fe, Mn, Ni, Pb, Sb and Zn by energy dispersive X-ray fluorescense (ED XRF) |
| CEN/TR 16269:2011 | Ambient air - Guide for the measurement of anions and cations in PM2,5 |
| VDI 2267 Blatt 5:1997-11 | Determination of suspended matter in ambient air - Determination of the mass concentration of Be, Cd, Co, Cr, Cu, Fe, Mn, Ni, Pb, Sb, V, Zn by optical emission spectrometry (ICP-OES) after sampling on filters and digestion in an oxidising agent |
| VDI 2463 Blatt 7:2014-05 | Particulate matter measurement - Determination of suspended particulate matter and gaseous chemical compounds in ambient air and indoor air - Active sampling via low-volume sampler (LVS) |
| EN 14907:2005 | Ambient air quality - Standard gravimetric measurement method for the determination of the PM2,5 mass fraction of suspended particulate matter |
| VDI 3498 Blatt 2:2002-07 | Ambient air measurement - Indoor air measurement - Measurement of polychlorinated dibenzo-p-dioxins and dibenzofurans; Method using small filters |
| DIN EN 15549:2008-06 | Air quality - Standard method for the measurement of the concentration of benzo[a]pyrene in ambient air |
| CEN/TR 16243:2011 | Ambient air quality - Guide for the measurement of elemental carbon (EC) and organic carbon (OC) deposited on filters |
| VDI 2463 Blatt 11:1996-10 | Particulate matter measurement - Measurement of mass concentration in ambient air - Filter method; Digitel DHA-80 filter changer |
| VDI 2267 Blatt 16:2007-07 | Determination of suspended matter in ambient air - Measurement of the mass concentration of As, Cd, Co, Cr, Cu, Ni, Pb, Sb, V und Zn as part of dust precipitation by atomic absorption spectrometry (AAS) |
| CEN/TS 16450:2013 | Ambient air - Automated measuring systems for the measurement of the concentration of particulate matter (PM10; PM2,5) |
| VDI 3867 Blatt 6:2012-12 | Measurement of particles in ambient air - Determination of the particle number concentration and number size distribution of aerosols - Electrical Low Pressure Impactor (ELPI) |
| VDI 2464 Blatt 3:2012-07 | Ambient air measurement - Indoor air measurement - Measurement of polybrominated diphenylether, hexabromocyclododecane and hexabromobenzene by GC/MS |
| VDI 3867 Blatt 5:2013-11 | Measurement of particles in ambient air - Determination of the particle number concentration and particle size distribution of aerosols - Time-of-flight spectrometer |
| VDI 2267 Blatt 15:2005-11 | Determination of suspended matter in ambient air - Measurement of the mass concentration of Al, As, Ca, Cd, Co, Cr, Cu, K, Mn, Ni, Pb, Sb, V, Zn as part of dust precipitation by mass spectrometry (ICP-MS) |
| VDI 2267 Blatt 7:1988-11 | Chemical analysis of particulates in ambient air; determination of thallium and its inorganic compounds as part of the dust precipitation by atomic absorption spectrometry |
| VDI 3867 Blatt 3:2012-08 | Measurement of particles in ambient air - Determination of the particle number concentration and number size distribution of aerosols - Electrical mobility spectrometer |
| VDI 2268 Blatt 1:1987-04 | Chemical analysis of particulate matter; determination of Ba, Be, Cd, Co, Cr, Cu, Ni, Pb, Sr, V, Zn in particulate emissions by atomic spectrometric methods |
| VDI 2267 Blatt 9:2002-07 | Determination of suspended particulates matter in ambient air - Measurement of the mass concentration of mercury - Sampling by sorption as amalgam and determination by atomic fluorescense spectrometry (AFS) with cold vapour technique |
| EN 1822-1:2009 | High efficiency air filters (EPA, HEPA and ULPA) - Part 1: Classification, performance testing, marking |
| VDI 3867 Blatt 2:2008-02 | Measurement of particulate matter in ambient air - Methods for characterizing test aerosols - Determination of the particle number concentration and particle size distribution - Condensation Particle Counter (CPC) |
| EN 15549:2008 | Air quality - Standard method for the measurement of the concentration of benzo[a]pyrene in ambient air |
| VDI 3867 Blatt 4:2011-06 | Measurement of particles in ambient air - Determination of the particle number concentration and particle size distribution of aerosols - Optical aerosol spectrometer |
| VDI 2267 Blatt 1:2012-10 | Determination of suspended matter in ambient air - Measurement of the element concentration after sampling on filters - Determination of Al, As, Ba, Ca, Cd, Co, Cr, Cu, Fe, K, Mg, Mn, Na, Ni, Pb, Sb, Se, Sn, Tl, V and Zn by graphite furnace atomic absorption spectrometry (GF-AAS), by optical emission spectrometry with inductively coupled plasma (ICP-OES) and inductively coupled plasma mass spectrometry (ICP-MS) |
| EN 12341:2014 | Ambient air - Standard gravimetric measurement method for the determination of the PM10 or PM2,5 mass concentration of suspended particulate matter |
| VDI 2267 Blatt 14:2003-12 | Determination of suspended matter in ambient air - Measurement of Al, As, Ca, Cd, Co, Cr, Cu, Fe, K, Mg, Mn, Na, Ni, Pb, V, Zn as part of dust deposition by optical emission spectrometry (ICP OES) |
| VDI 3498 Blatt 1:2002-07 | Ambient air measurement - Indoor air measurement - Measurement of polychlorinated dibenzo-p-dioxins and dibenzofurans; Method using large filters |
| VDI 2267 Blatt 2:1983-02 | Determination of suspended particulates in ambient air; measurement of lead by X-ray fluorescence |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.