DIN EN 13232-7:2014-07 (Draft)

Foreword
Introduction
1 Scope
2 Normative references
3 Types of crossing with moveable parts
  3.1 Common crossings with moveable parts
  3.2 Obtuse crossings with moveable parts
  3.3 Materials
  3.4 Geometry
  3.5 Inclination of the running table
  3.6 Construction
  3.7 Relationship with the adjacent track
4 Terms and definitions
  4.1 Common crossing with moveable point
  4.2 Common crossing with moveable wing rails
  4.3 Obtuse crossing with moveable parts
5 Design requirements
  5.1 Geometrical data
  5.2 Rolling stock data
      5.2.1 Maximum axle load
      5.2.2 Maximum speed
      5.2.3 Wheel profile, diameter, back to back and wheel
            set dimensions
      5.2.4 Note
  5.3 Supports and fastenings
  5.4 Interface between crossing with moveable parts and
      operating system
  5.5 Transfer of longitudinal track forces
  5.6 Other requirements
  5.7 Drawings
6 Tolerances and inspection
  6.1 General
  6.2 Tools and instruments
  6.3 Critical dimensions
      6.3.1 General
      6.3.2 Critical dimensions for common crossings with
            moveable point
      6.3.3 Critical dimensions for common crossings with
            moveable wing rails
      6.3.4 Critical dimensions for obtuse crossings with
            moveable parts
  6.4 Certification
  6.5 Methods of examination for structural defects
      6.5.1 Visual
      6.5.2 Dye penetrant and/or magnetic particle
      6.5.3 Ultrasound
      6.5.4 Radiography
7 Limits and extent of supply
8 Identification marks
Annex ZA (informative) Relationship between this European
                       Standard and the Essential Requirements
                       of EU Directive 96/48/EC of 23 July 1996
                       on the interoperability of the
                       trans-European high-speed rail system
                       amended by Directive 2004/50/EC of 29
                       April 2004
Bibliography

Establishes a working terminology for crossings with moveable parts, which means crossings with moveable parts to close the gap of the running edge, and their constituent parts, and identify the main types. Lists the minimum informative requirements for the manufacture of crossings with moveable parts and/or their constituent parts.