DIN EN 13380:2001-10

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
4 Installation techniques
5 Product stages "M"-stage and "I"-stage
6 General requirements
   6.1 General
   6.2 Dimensions
   6.3 Geometry
   6.4 Smoothness of bore, appearance and soundness
   6.5 Watertightness
   6.6 Temperature
   6.7 Corrosion resistance
   6.8 Abrasion resistance
   6.9 Load bearing capacity and stiffness
   6.10 Dimensional stability
   6.11 Long-term behaviour
   6.12 Durability
   6.13 Sealing elements
   6.14 Fitness for installation
7 Specimen for testing
8 General test methods
   8.1 General
   8.2 Measurement of diameters and wall thicknesses
   8.3 Measurement of deviation from geometry
   8.4 Testing of smoothness of bore, appearance and
        soundness
   8.5 Watertightness test
   8.6 Crushing and stiffness test
   8.7 Tests for fitness for installation
9 Quality control
10 Marking
Annex A (informative) The following chart gives examples
        of rehabilitation techniques for pipelines
Annex B (informative) Examples of components and materials
        used for repair and renovation which do "change"
        and which do "not change", respectively, their
        properties from "M"-stage to "I"-stage:
Annex C (informative) Examples for requirements to be
        tested regarding the system of renovation/repair
        techniques ("M"-stage and/or "I"-stage)
Bibliography

This standard is included in DIN Handbook 152. Defines general requirements and general test methods for components such as pipes and fittings with their respective joints, manholes, inspection chambers and materials such as mortar and chemicals all intended to be used for repair and renovation of drain and sewer systems.