EN 13229:2001/A2:2004/AC:2007
|
INSET APPLIANCES INCLUDING OPEN FIRES FIRED BY SOLID FUELS - REQUIREMENTS AND TEST METHODS |
EN 10120:2017
|
Steel sheet and strip for welded gas cylinders |
EN ISO 228-2:2003
|
Pipe threads where pressure-tight joints are not made on the threads - Part 2: Verification by means of limit gauges (ISO 228-2:1987) |
EN 50165 : 97 AMD 1 2001
|
ELECTRICAL EQUIPMENT ON NON-ELECTRIC APPLIANCES FOR HOUSEHOLD AND SIMILAR PURPOSES - SAFETY REQUIREMENTS |
EN 10027-2:2015
|
DESIGNATION SYSTEMS FOR STEELS - PART 2: NUMERICAL SYSTEM |
EN 10029:2010
|
Hot-rolled steel plates 3 mm thick or above - Tolerances on dimensions and shape |
ISO 1928:2009
|
Solid mineral fuels Determination of gross calorific value by the bomb calorimetric method and calculation of net calorific value |
EN 13240:2001/A2:2004/AC:2007
|
ROOMHEATERS FIRED BY SOLID FUEL - REQUIREMENTS AND TEST METHODS |
ISO 334:2013
|
Solid mineral fuels Determination of total sulfur Eschka method |
EN 10111:2008
|
Continuously hot rolled low carbon steel sheet and strip for cold forming - Technical delivery conditions |
EN 10088-2:2014
|
STAINLESS STEELS - PART 2: TECHNICAL DELIVERY CONDITIONS FOR SHEET/PLATE AND STRIP OF CORROSION RESISTING STEELS FOR GENERAL PURPOSES |
EN 10028-2:2017
|
Flat products made of steels for pressure purposes - Part 2: Non-alloy and alloy steels with specified elevated temperature properties |
EN ISO 228-1:2003
|
Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation (ISO 228-1:2000) |
ISO 7-1:1994
|
Pipe threads where pressure-tight joints are made on the threads Part 1: Dimensions, tolerances and designation |
EN ISO 9001:2015
|
Quality management systems - Requirements (ISO 9001:2015) |
ISO 9001:2015
|
Quality management systems — Requirements |
EN 1563:2011
|
Founding - Spheroidal graphite cast irons |
EN 10226-3:2005
|
Pipes threads where pressure tight joint are made on the threads - Part 3: Verification by means of limit gauges |
ISO 687:2010
|
Solid mineral fuels — Coke — Determination of moisture in the general analysis test sample |
ISO 501:2012
|
Hard coal — Determination of the crucible swelling number |
CEN/TS 14774-1:2004
|
Solid biofuels - Methods for determination of moisture content - Oven dry method - Part 1: Total moisture - Reference method |
ISO 228-2:1987
|
Pipe threads where pressure-tight joints are not made on the threads Part 2: Verification by means of limit gauges |
ISO 1171:2010
|
Solid mineral fuels — Determination of ash |
ISO 228-1:2000
|
Pipe threads where pressure-tight joints are not made on the threads Part 1: Dimensions, tolerances and designation |
ISO 562:2010
|
Hard coal and coke — Determination of volatile matter |
EN 1561:2011
|
Founding - Grey cast irons |