DIN EN 62219:2003-01

1 Scope
2 Normative references
3 Definitions
4 Designation system
5 Requirements for stranded conductors
  5.1 Material
  5.2 Formed wires
  5.3 Conductor sizes
  5.4 Surface
  5.5 Stranding
  5.6 Joints
  5.7 Linear density - Mass per unit length
  5.8 Conductor strength
6 Tests
  6.1 Classification of tests
  6.2 Test requirements for new conductor designs
  6.3 Sample size
  6.4 Sample length
  6.5 Type tests
  6.6 Sample tests
  6.7 Inspection
  6.8 Acceptance or rejection
7 Packaging and marking
  7.1 Packaging
  7.2 Marking and tare
  7.3 Random lengths
Annex A (normative) Information to be supplied by purchaser
Annex B (normative) Stress-strain test method
Annex C (normative) Nominal mass of grease for stranded
                       conductors using formed wires
Annex D (informative) Recommended conductor sizes and tables
                       of conductor properties
Annex ZA (normative) Normative references to international
                       publications with their corresponding
                       European publications

Specifies the electrical and mechanical characteristics of concentric lay, overhead conductors of wires formed or shaped before, during or after stranding, made of combinations of any of the following metal wires: a) hard aluminium as per IEC 60889 designated A1; b) hard aluminium as per IEC 60889 designated A1F wire shaped before stranding; c) hard aluminium alloy as per IEC 60104 designated A2 or A3; d) hard aluminium alloy as per IEC 60104 designated A2F or A3F shaped before stranding; e) regular strength steel, designated S1A OR S1B, where A AND B are zinc coating classes, corresponding respectively to 1 and 2; f) high strength steel, designated S2A or S2B; g) extra high strength steel, designated S3A; h) aluminium clad steel, designated SA.