EIA 585 : 1991

1. SCOPE
   1.1 PURPOSE
   1.2 APPLICATION
   1.3 INSPECTION
   1.4 INSPECTION BY ATTRIBUTES
   1.5 UNIT OF PRODUCT
   1.6 NONCONFORMANCE
2. PARTS PER MILLION (PPM)
   2.1 EXPRESSION OF NONCONFORMANCE
   2.2 PARTS PER MILLION (PPM)
3. SAMPLING PLAN APPLICATION
   3.1 NOTATION
   3.2 USE
   3.3 SELECTION
4. SUBMISSION OF PRODUCT
   4.1 LOT
   4.2 FORMATION OF LOTS
   4.3 LOT SIZE
   4.4 PRESENTATION OF LOTS
5. ACCEPTANCE AND REJECTION
   5.1 ACCEPTABILITY OF LOTS
   5.2 NONCONFORMING UNITS
   5.3 SPECIAL RESERVATION FOR CRITICAL DEFECTS
6. DRAWING OF SAMPLESES
   6.1 SAMPLE
   6.2 REPRESENTATIVE SAMPLING
APPENDIX A - OPERATING CHARACTERISTIC (OC) CURVES FOR ISOLATED
             LOT ACCEPTANCE PLANS, FOR THE COMBINATION OF LOT
             SIZE, N, AND SAMPLE SIZE, n, USED IN TABLE 2
APPENDIX B - TYPICAL SAMPLING PLANS
APPENDIX C - USE OF EIA STANDARD "ZERO ACCEPTANCE NUMBER
             SAMPLING PROCEDURES..."

Describes the need for sampling plans that can augment MIL-STD-105, are based upon a zero acceptance number, and address quality (nonconformance) levels in the parts per million range.