EN 13016-2:2007

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Reagents
6 Apparatus
7 Sampling
8 Sample preparation
9 Preparation of apparatus
10 Calibration of apparatus
   10.1 Pressure transducer
   10.2 Temperature measuring device
11 Verification of apparatus
12 Procedure
13 Calculation
14 Expression of results
15 Precision
   15.1 Repeatability, r
   15.2 Reproducibility, R
16 Test report
Annex A (informative) - Derivation of equations used to
                        calculate AVP
        A.1 Theory
        A.2 Derivation of equation
        A.3 Air correction at test temperature
        A.4 Calculation
Bibliography

petroleum products at elevated temperatures.The conditions used in the test described in this standard are a vapour to liquid ratio of 3:2 and an initial injection temperature of 37,8 °C or 30,0 °C.The method described is suitable for testing air-saturated samples that exert an air-saturated vapour pressure of between 9 kPa and 500 kPa at temperatures between 40 °C and 100 °C. This European Standard is applicable to fuels containing oxygenated compounds up to the limits stated in the relevant EC Directive 85/536/EEC [3].NOTE 1If a sample injection is into a test chamber which is raised to 37,8 °C and the vapour to liquid ratio is 4:1, the initial measurement corresponds with the measurement in Part 1 of this standard.NOTE 2For the purposes of this European Standard, the term % (V/V) is used to represent the volume fraction.WARNING - Use of this standard may involve hazardous materials, operations and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.