EN 134100:1995

Foreword
1 General
1.1 Scope
1.2 Related documents
1.3 Information to be given in a detail specification
1.4 Terminology
1.5 Marking
2 Preferred ratings and characteristics
2.1 Preferred climatic categories
2.2 Preferred values of ratings
3 Quality assessment procedures
3.1 Primary stage of manufacture
3.2 Structurally similar components
3.3 Certified test records of released lots
3.4 Qualification approval
3.5 Quality conformance inspection
4 Test and measurement procedures
4.1 Preconditioning
4.2 Visual examination and check of dimensions
4.3 Electrical tests
4.4 Operating torque
4.5 Locking
4.6 Locking torque proof
4.7 End stop torque
4.8 Thrust and pull (axial)
4.9 Side thrust
4.10 Robustness of terminations
4.11 Solderability
4.12 Resistance to soldering heat
4.13 Component solvent resistance
4.14 Solvent resistance of the marking
4.15 Rapid change of temperature
4.16 Vibration
4.17 Bump
4.18 Shock
4.19 Climatic sequence
4.20 Damp heat, steady state
4.21 Electrical endurance
4.22 Mechanical endurance
Annexes
A.1 (normative) Test plan for qualification approval
A.2 (normative) Test plan for quality conformance inspection
      - lot-by-lot tests
A.3 (normative) Test plan for quality conformance inspection -
      periodic tests
A.4 (normative) Test schedule for qualification approval

Describes the tests on capacitors to establish, under laboratory conditions, their suitability for use over stated ranges of temperature, air pressure and humidity, their ability to withstand specified conditions of mechanical shock such as are to be expected under transit or operational conditions, their ability to withstand the rigours of normal assembly processes attendant on their incorporation in equipment. See IEC 612.