EN 13499:2003

Foreword
1 Scope
2 Normative references
3 Terms, definitions, symbols, units and abbreviated terms
  3.1 Terms and definitions
  3.2 Symbols, units and abbreviated terms
4 Requirements
  4.1 General
  4.2 Thermal resistance
  4.3 Mechanical resistance and stability of the system
       4.3.1 Bond strength of the base coat to the EPS board
       4.3.2 Bond strength of the adhesive to the EPS board for
             ETICS fixed by an adhesive
       4.3.3 Pull-off resistance of the ETICS fixed by mechanical
             fixing
  4.4 Reaction to fire
  4.5 EPS boards
  4.6 Tensile strength of the reinforcement
  4.7 Liquid water permeability of the system surface
  4.8 Resistance to impact
  4.9 Resistance to penetration
  4.10 Water vapour permeability
  4.11 Durability and adhesion of the finishing material on the
       base coat
5 Test methods
  5.1 Sampling
  5.2 Conditioning
       5.2.1 Conditioning of the test specimen for the
             determination of the tensile bond strength of the
             adhesive to the thermal insulation material
       5.2.2 Conditioning of the test specimen in accordance with
             EN 1062-11 for the determination of the tensile bond
             strength of the base coat to the thermal insulation
             material, liquid water permeability of the system
             surface, resistance to impact, resistance to
             penetration, water vapour permeability, durability
             and adhesion of the finishing material on the base
             coat
  5.3 Testing
6 Designation code
7 Evaluation of conformity
8 Marking and labelling
  8.1 The entire and specific information of all components of
       the kit has to be given on an accompanying document that
       contains:
  8.2 Components conforming to this standard shall be clearly
       marked, either on the product or on the label with the
       following information:
  8.3 Additional information:
       8.3.1 Reinforcement
       8.3.2 Adhesive:
       8.3.3 Base coat:
       8.3.4 Finishing coat
       8.3.5 EPS-Boards
       8.3.6 Rails
       8.3.7 Anchors
Annex A (normative) Factory production control
Annex B (informative) Additional information for customer and
        designers
      B.1 Resistance of the systems surface to cracking
Bibliography

This European Standard specifies the requirements for factory made products for external thermal insulation composite systems (ETICS) based on expanded polystyrene, delivered as a kit, and used as thermal insulation for buildings.The standard describes product characteristics and includes procedures for testing, marking and labelling.ETICS are applied to external surfaces of new or existing walls and/or soffits to improve the thermal insulation. ETICS include special fittings (base profiles, corner profiles, etc.) to connect them to adjacent building structures (apertures, corners, parapets, etc.). ETICS give protection against weathering and improve the appearance of the buildings. They do not contribute the stability of the wall and/or soffits on which they are installed. The standard covers systems where the thermal insulation material is required for the load transfer to the substrate.This standard covers systems with a declared thermal resistance equal to or greater than 1 m²×K/W.The requirements from national regulations concerning the mechanical resistance and stability of ETICS should be taken into account.This standard does not cover the strength between the ETICS and the building surface to which it shall be fixed, i. e. the substrate.