EN 140101:2008

Introduction
1 Characteristics and ratings
  1.1 Dimensions and ratings
  1.2 Derating curve
  1.3 Resistance range and tolerance on rated
       resistance
  1.4 Variation of resistance with temperature
       and temperature rise
  1.5 Climatic categories
  1.6 Limits for change of resistance at tests
  1.7 Non-linear properties
  1.8 Tests related to soldering
  1.9 Marking, packaging and ordering designation
  1.10 Additional information (not for inspection
       purpose)
2 Quality assessment procedures
  2.1 General
  2.2 Qualification Approval
  2.3 Quality Conformance Inspection
Annex A (normative) - Fixed sample size Qualification
                      Approval and Quality Conformance
                      Inspection test schedule for fixed
                      low power film resistors
Annex B (informative) - Letter symbols and abbreviations
Bibliography

A Blank Detail Specification is a supplementary document to the sectional specification and containsrequirements for style and layout and minimum content of detail specifications. Detail specifications notcomplying with these requirements shall not be considered as being in accordance with European standardsnor shall they be so described.In the preparation of the detail specification the content of EN 140100:2008, 1.2 shall be taken into account.The detail specification should be written by using the preferred values given in EN 140100.The detail specification should contain a table of contents prior the first page of the actual specification.For the use of SI units refer to ISO 1000, for the use of letter symbols to be used in electrical technologyrefer to EN 60027-1.