EN 14286:2008

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Selection of materials
5 Designation of the products
6 Ordering information
7 Requirements
   7.1 General
   7.2 Technical conditions for inspection and delivery
   7.3 Mechanical properties
   7.4 Surface conditions
   7.5 Tolerances on dimensions and form
8 Inspection
   8.1 Inspections to be carried out
   8.2 Type and content of inspection documents
9 Quality assurance
10 Marking
Annex A (informative) - Explanation of temper designations
        used in Table 1 based on definitions of EN 515
Bibliography

This document specifies the technical conditions of inspection and delivery, the mechanical properties, the tolerances on dimensions and form of rolled semi-finished aluminium alloy products intended for tanks for the storage and transportation of dangerous goods, in particular of gasoline and other liquid hydrocarbons.It applies to hot or cold-rolled strip, sheet and plate with a thickness from 3,0 mm and up to and including 12,0 mm used as a wall material.NOTECompliance with the present document does not ensure compliance with national or international regulations. The user of the document is responsible for checking that the material he orders or sells complies with all applicable regulations. Depending on the chemical and physical properties of the dangerous good to be transported or stored, it can be necessary to agree on additional properties or inspection conditions in order to comply with applying regulations.