EN 14648:2007

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
  4.1 General
  4.2 Category of use (first digit)
  4.3 Durability (second digit)
  4.4 Mass (third digit)
  4.5 Fire resistance (fourth digit)
  4.6 Safety in use (fifth digit)
  4.7 Corrosion resistance (sixth digit)
  4.8 Example of classification of shutter hardware
5 Requirements
  5.1 Dangerous substances
  5.2 Category of use (first digit)
  5.3 Durability (second digit)
  5.4 Mass (third digit)
  5.5 Fire resistance (fourth digit)
  5.6 Safety in use (fifth digit)
  5.7 Corrosion resistance (sixth digit)
6 Test equipment
  6.1 Test rig
  6.2 Beam to accommodate the frame hinges
  6.3 Essentially the beam has a cross-section of (100 X 100)
      mm, and a length of 1600 mm. Test shutter
  6.4 Moving device
7 Test method
  7.1 Samples
  7.2 Procedures
  7.3 Durability test
  7.4 Overload tests
  7.5 Corrosion resistance test
8 Marking
Annex A (informative) Shutter hardware terminology
Annex B (informative) Deviation after the durability test
Annex C (informative) Test equipment
Annex D (normative) Flow chart of test procedures
Bibliography

This European Standard specifies performance requirements for the strength and durability of hardware for the operation of movable shutter sashes including requirements and test methods.This European Standard is applicable to hardware for side-hung and top-hung shutters comprising one or more shutter sashes. The requirements and test methods of this European Standard are applicable to the following:-shapes and dimensions of sash hinges, double-sashed shutter hinges and frame hinges-shapes and dimensions of frame hinges and sash hinges with arrest functionOnly the corrosion requirements of 4.7 are applicable to double-sash shutter latches, locking-rods, decorative corner-brackets, handles, stops without automatic arrest function, central hinges, shutter catches with automatic arrest function and other hardware components for window and door shutters.NOTE 1The sashes of side-hung shutters may have additional projecting shutter-inserts. The hardware for these projecting shutter-inserts is not covered by the scope of this European Standard.NOTE 2If due to the hardware fixing type or the dead weight of the described test shutter, this can not be used, a corresponding system sash with the same dimensions (800 mm wide  1 400 mm high) can be tested.This is particularly valid for hardware used exclusively in a complete modular system from a systems manufacturer (consisting of the hardware components, frame profiles and panel units as well as the necessary fixing materials).NOTE 3Tower bolts and locking-rods should conform to EN 12051.NOTE 4Fixings used to attach hardware to shutters are not covered by this European Standard.To allow a choice of items from a single source, so-called "product group" of elements may be nominated by the manufacturer. The single components may be called "product group" components, if these are approved by accredited test authorities commissioned to test, based upon the comparable features; for example hinge features wit