EN 16304:2013
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
Automatic vent valves for gas burners and gas burning appliances
30-09-2013
13-03-2013
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Units of measurement and test conditions
6 Construction requirements
7 Performance
8 EMC/Electrical requirements
9 Marking, installation and operating instructions
Annex A (informative) - Gas connections in common
use in the various countries
Annex B (informative) - Leak-tightness test - volumetric
method
Annex C (informative) - Leak-tightness test - pressure
loss method
Annex D (normative) - Conversion of pressure loss into
leakage rate
Annex E (normative) - Electrical/electronic component
fault modes
Annex F (normative) - Additional requirements for safety
accessories and pressure accessories as defined
in EU Directive 97/23/EC
Annex G (normative) - Materials for pressurised parts
Annex H (informative) - Additional materials for
pressurised parts
Annex I (normative) - Requirements for controls used
in DC supplied gas burners and gas burning
appliances
Annex ZA (informative) - Relationship between this
European Standard and the Essential
Requirements of EU Directive 2009/142/EC
relating to appliances burning gaseous fuels
Bibliography
This European Standard specifies the safety, construction and performance requirements for automatic vent valves for use with gas burners, gas appliances and similar use, hereafter referred to as ‘valves’. This European Standard is applicable to: -valves with declared maximum inlet pressures up to and including 500 kPa (5 bar) of nominal connection sizes up to and including DN 100 for use with one or more fuel gases in accordance with EN 437:2003+A1:2009;-electrically operated valves;-valves actuated by fluids where the control valves for these fluids are actuated electrically, but not to any external electrical devices for switching the control signal or actuating energy;-valves fitted with open position indicator switches.NOTEProvisions for final product inspection and testing by the manufacturer are not specified.
| Committee |
CEN/TC 58
|
| DevelopmentNote |
Supersedes PREN 16304. (04/2013)
|
| DocumentType |
Standard
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Withdrawn
|
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.