EN 16830:2017

European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Test conditions and measurement tolerances
6 Construction requirements
7 Performance
8 Electrical requirements
9 Electromagnetic compatibility (EMC)
10 Marking, installation and operating instructions
Annex A (informative) - Abbreviations and Symbols
Annex B (informative) - Leak-tightness test for gas
        controls - volumetric method
Annex C (informative) - Leak-tightness test for gas
        controls - pressure loss method
Annex D (normative) - Conversion of pressure loss
        into leakage rate
Annex E (normative) - Electrical/electronic component
        fault modes
Annex F (normative) - Additional requirements for safety
        accessories and pressure accessories as defined in
        EU Directive 97/23/EC
Annex G (normative) - Materials for pressurized parts
Annex H (normative) - Additional materials for
        pressurized parts
Annex I (normative) - Requirements for controls used
        in DC supplied burners and appliances burning
        gaseous or liquid fuels
Annex J (normative) - Method for the determination of a
        Safety Integrity Level (SIL)
Annex K (normative) - Method for the determination of a
        Performance Level (PL)
Annex L (informative) - Relationship between Safety Integrity
        Level (SIL) and Performance Level (PL)
Annex M (normative) - Reset functions
Annex N (informative) - Guidance document on
        Environmental Aspects
Annex O (normative) - Seals of elastomer, cork and
        synthetic fibre mixtures
Bibliography

This European Standard specifies the safety, design, construction and performance requirements for Temperature Control Function (TCF) and Combustion Product Discharge Safety Device (TTB) intended for use with burners and appliances using gaseous or liquid fuels.It also describes the test procedures for checking compliance with these requirements.This European Standard is applicable to AC and DC supplied TCF and TTB (for TCF and TTB supplied by stand-alone battery system, battery systems for mobile applications or systems which are intended to be connected to DC supply networks, see Annex I).This European Standard is applicable to electronically based TTB and TCF only.