EN 50320:2000

1 General
   1.1 Scope
   1.2 Structure of DCSR
2 Reference table
3 Responses
   3.1 accepted
   3.2 rejected
   3.3 interim
   3.4 command_not_implemented
   3.5 busy
   3.6 syntax_error
4 Commands and notifications
   4.1 get_receiver_capability
   4.2 notify_receiver_capability
   4.3 tune
   4.4 get_tii
   4.5 notify_tii
   4.6 select_tii
   4.7 get_pad
   4.8 notify_pad
   4.9 select_pad
   4.10 get_figs
   4.11 notify_fig
   4.12 select_figs
   4.13 get_channel
   4.14 notify_channel
   4.15 select_channel
   4.16 get_selection_status
   4.17 notify_selection_status
   4.18 search_for_ensemble
   4.19 notify_search_for_ensemble
   4.20 set_drc
   4.21 get_audio_info
   4.22 notify_audio_info
   4.23 get_dab_status
   4.24 notify_dab_status
   4.25 set_dab_status_auto_notification
   4.26 get_active_info
   4.27 notify_active_info
   4.28 notify_service_following
   4.29 manufacturer_specific_command
   4.30 manufacturer_specific_notification
   4.31 notify_error_message
5 Example of DCSR coding
6 Guidelines for data fields, reserved for future
   use (Rfu's) or addition (Rfa's) and table
   entries, reserved for future definition (Rfd's)
7 Glossary
8 References

This standard describes a command set which should be used to control DAB receivers. The coding of these commands is also described. This command set is intended to be used on different physical bus systems. The coding should be mapped transparently on different physical interfaces.Selection conflict management, dynamic bandwidth problems and the device addressing are not within the scope of this document.