EN 50607:2015

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviations
4 System architecture
5 SCIF control signals
6 Structure and format of the messages of the 2nd
  generation single cable distribution system (SCD2)
7 SCD2 commands
8 Conventions
9 Traffic collision management rules
Annex A (normative) - Implementation rules
Bibliography

This standard describes:the system physical structure;the system control signals, which implement a set of messages using DiSEqC physical layer but not the DiSEqC message structure; the definition of identified configurations;the management of the potential collisions in the control signals traffic.Figure 1 illustrates the physical system configuration considered in this standard.Several satellite signal demodulators can receive signals from any of the input signal banks (Bank 1, Bank 2,  Bank M, with M  256) of the LNB or the switch. The signals selected by the demodulators (or receivers) are transported via a single cable to these demodulators (Receiver 1, Receiver 2,  Receiver N, with N  32). To achieve these single cable distributions, the Single Cable Interface (SCIF, likely embedded in a LNB or a Switch) features some specific functions and characteristics.