Skip to content
Please enter a keyword to search

  • EN 60358-1:2012

    View superseded by
    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    View superseded by

    COUPLING CAPACITORS AND CAPACITOR DIVIDERS - PART 1: GENERAL RULES (IEC 60358-1:2012)

    Available format(s): 

    Superseded date:  22-02-2020

    Language(s): 

    Published date:  12-01-2013

    Publisher:  European Committee for Standards - Electrical

    Pure ENs are not available for sale, please purchase a suitable national adoption

    Sorry this product is not available in your region.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    FOREWORD
    INTRODUCTION
    1 Scope
    2 Normative references
    3 Terms and definitions
    4 Service conditions
    5 Ratings
    6 Design requirements
    7 Test conditions
    8 Classification of tests
    9 Routine tests
    10 Type tests
    11 Special tests - Mechanical strength test
    12 Marking of the equipment
    Annex A (informative) - Typical diagram of an equipment
    Annex B (informative) - Partial discharge test circuit
            and instrumentation
    Annex C (normative) - Radio interference voltage -
            Measurement circuit
    Bibliography
    Annex ZA (normative) - Normative references to international
             publications with their corresponding European
             publications

    Abstract - (Show below) - (Hide below)

    Pertains to: Capacitors, with rated voltage > 1000 V, connected line to ground with the low voltage terminal either permanently earthed or connected to devices, for applications listed hereunder and other similar uses.

    General Product Information - (Show below) - (Hide below)

    Committee SR 33
    Development Note Partially supersedes HD 597. (08/2012)
    Document Type Standard
    Publisher European Committee for Standards - Electrical
    Status Superseded
    Superseded By
    Supersedes

    Standards Referenced By This Book - (Show below) - (Hide below)

    CEI EN 60358-2 : 2015 COUPLING CAPACITORS AND CAPACITOR DIVIDERS - PART 2: AC OR DC SINGLE-PHASE COUPLING CAPACITOR CONNECTED BETWEEN LINE AND GROUND FOR POWER LINE CARRIER-FREQUENCY (PLC) APPLICATION
    I.S. EN 60358-3:2014 COUPLING CAPACITORS AND CAPACITOR DIVIDERS - PART 3: AC OR DC COUPLING CAPACITORS FOR HARMONIC-FILTERS APPLICATIONS
    BS EN 60358-3:2014 Coupling capacitors and capacitor dividers AC or DC coupling capacitors for harmonic-filters applications
    I.S. EN 60143-2:2013 SERIES CAPACITORS FOR POWER SYSTEMS - PART 2: PROTECTIVE EQUIPMENT FOR SERIES CAPACITOR BANKS (IEC 60143-2:2012 (EQV))
    BS EN 60143-2:2013 Series capacitors for power systems Protective equipment for series capacitor banks
    CEI EN 60143-2 : 2014 SERIES CAPACITORS FOR POWER SYSTEMS - PART 2: PROTECTIVE EQUIPMENT FOR SERIES CAPACITOR BANKS
    CEI EN 60358-3 : 2015 COUPLING CAPACITORS AND CAPACITOR DIVIDERS - PART 3: AC OR DC COUPLING CAPACITORS FOR HARMONIC-FILTERS APPLICATIONS
    BS EN 60358-2:2013 Coupling capacitors and capacitor dividers AC or DC single-phase coupling capacitor connected between line and ground for power line carrier-frequency (PLC) application
    I.S. EN 60358-2:2013 COUPLING CAPACITORS AND CAPACITOR DIVIDERS - PART 2: AC OR DC SINGLE-PHASE COUPLING CAPACITOR CONNECTED BETWEEN LINE AND GROUND FOR POWER LINE CARRIER-FREQUENCY (PLC) APPLICATION
    EN 60358-2:2013 Coupling capacitors and capacitor dividers - Part 2: AC or DC single-phase coupling capacitor connected between line and ground for power line carrier-frequency (PLC) application
    EN 60143-2:2013 Series capacitors for power systems - Part 2: Protective equipment for series capacitor banks
    EN 60358-3:2014 Coupling capacitors and capacitor dividers - Part 3: AC or DC coupling capacitors for harmonic-filters applications

    Standards Referencing This Book - (Show below) - (Hide below)

    IEC 60060-2:2010 High-voltage test techniques - Part 2: Measuring systems
    IEC 60038:2009 IEC standard voltages
    IEC 60270:2000+AMD1:2015 CSV High-voltage test techniques - Partial discharge measurements
    IEC 62155:2003 Hollow pressurized and unpressurized ceramic and glass insulators for use in electrical equipment with rated voltages greater than 1 000 V
    IEC 60050-601:1985 International Electrotechnical Vocabulary (IEV) - Part 601: Generation, transmission and distribution of electricity - General
    IEC 60422:2013 Mineral insulating oils in electrical equipment - Supervision and maintenance guidance
    IEC 60358-2:2013 Coupling capacitors and capacitor dividers - Part 2: AC or DC single-phase coupling capacitor connected between line and ground for power line carrier-frequency (PLC) application
    EN 60060-1:2010 High-voltage test techniques - Part 1: General definitions and test requirements
    IEC 60358-3:2013 Coupling capacitors and capacitor dividers - Part 3: AC or DC coupling capacitor for harmonic-filters applications
    IEC TR 62271-300:2006 High-voltage switchgear and controlgear - Part 300: Seismic qualification of alternating current circuit-breakers
    EN 61462:2007 Composite hollow insulators - Pressurized and unpressurized insulators for use in electrical equipment with rated voltage greater than 1 000 V - Definitions, test methods, acceptance criteria and design recommendations
    EN 60270:2001/A1:2016 HIGH-VOLTAGE TEST TECHNIQUES - PARTIAL DISCHARGE MEASUREMENTS (IEC 60270:2000/A1:2015)
    IEC 60085:2007 Electrical insulation - Thermal evaluation and designation
    IEC 61462:2007 Composite hollow insulators - Pressurized and unpressurized insulators for use in electrical equipment with rated voltage greater than 1 000 V - Definitions, test methods, acceptance criteria and design recommendations
    EN 60068-2-17:1994 Environmental testing - Part 2: Tests - Test Q: Sealing
    IEC 60068-2-17:1994 Basic environmental testing procedures - Part 2-17: Tests - Test Q: Sealing
    IEC 60358-1:2012 Coupling capacitors and capacitor dividers - Part 1: General rules
    EN 60071-1:2006/A1:2010 INSULATION CO-ORDINATION - PART 1: DEFINITIONS, PRINCIPLES AND RULES
    CISPR TR 18-2:2017 Radio interference characteristics of overhead power lines and high-voltage equipment - Part 2: Methods of measurement and procedure for determining limits
    IEC 60050-321:1986 International Electrotechnical Vocabulary (IEV) - Part 321: Instrument transformers
    IEC 61869-5:2011 Instrument transformers - Part 5: Additional requirements for capacitor voltage transformers
    IEC 60050-436:1990 International Electrotechnical Vocabulary (IEV) - Part 436: Power capacitors
    IEC 60060-1:2010 High-voltage test techniques - Part 1: General definitions and test requirements
    IEC 60071-1:2006+AMD1:2010 CSV Insulation co-ordination - Part 1: Definitions, principles and rules
    CISPR 16-1:1999+AMD1:2002 CSV Specification for radio disturbance and immunity measuring apparatus and methods - Part 1: Radio disturbance and immunity measuring apparatus
    EN 60038 : 2011 CENELEC STANDARD VOLTAGES (IEC 60038:2009, MODIFIED)
    View more information

    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective