EN 60384-17:2005

FOREWORD
1 General
  1.1 Scope
  1.2 Object
  1.3 Normative references
  1.4 Information to be given in a
       detail specification
  1.5 Terms and definitions
  1.6 Marking
2 Preferred ratings and characteristics
  2.1 Preferred characteristics
  2.2 Preferred values of ratings
3 Quality assessment procedures
  3.1 Primary stage of manufacture
  3.2 Structurally similar components
  3.3 Certified records of released lots
  3.4 Qualification approval
  3.5 Quality conformance inspection
4 Test and measurement procedures
  4.1 Visual examination and check of dimensions
  4.2 Electrical tests
  4.3 Robustness of terminations
  4.4 Resistance to soldering heat
  4.5 Solderability
  4.6 Rapid change of temperature
  4.7 Vibration
  4.8 Bump
  4.9 Shock
  4.10 Climatic sequence
  4.11 Damp heat, steady state
  4.12 Endurance
  4.13 Charge and discharge
  4.14 Component solvent resistance
  4.15 Solvent resistance of the marking
Annex ZA (normative) Normative references to international
                     publications with their corresponding
                     European publications
Bibliography

applies to fixed capacitors with metallized electrodes and polypropylene dielectric for use in electronic equipment. Capacitors which have mixed foil and metallized electrodes are also within the scope of this standard. These capacitors may have 'self-healing' properties depending on conditions of use. Capacitors covered by this specification are mainly intended for use with alternating voltage and/or for pulse applications. The maximum reactive power applicable is 10 000 var and the maximum peak voltage is 3 000 V.