EN 60728-1:2014

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
4 Methods of measurement at system outlet
5 Performance requirements at system outlet
6 Performance requirements at receiving antennas
7 Performance requirements at home network interfaces
  of cable networks
Annex A (informative) - Reception of television signals
Annex B (normative) - Calibration of modulation depth
Annex C (normative) - Equipment required - Additional
        items
Annex D (normative) - Preliminary checks on the measuring
        equipment for carrier-tonoise ratio
Annex E (normative) - Correction factors
Annex F (normative) - Calibration of the measuring receiver
Annex G (normative) - Correction factors for noise
Annex H (normative) - Null packet and PRBS definitions
Annex I (normative) - Digital signal level and bandwidth
Annex J (normative) - Correction factor for a spectrum
        analyser
Annex K (informative) - Differences in some countries
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their corresponding
         European publications
Annex ZB (informative) - A-deviations

IEC 60728-1:2014 is applicable to any cable network (including individual receiving systems) having in the forward path a coaxial cable output and primarily intended for television and sound signals operating between about 30 MHz and 3 000 MHz. It specifies the basic methods of measurement of the operational characteristics of cable network having coaxial cable outputs in order to assess the performance of these systems and their performance limits. This fifth edition cancels and replaces the fourth edition published in 2007 and constitutes a technical revision. It includes the following changes:- redrafting of measurement procedure and updating of performance requirements to include DVB-T2 signals;- reference to IEC 60728-1-1 for home networks;- reference to IEC 60728-1-2 for performance requirements at system outlet in operation.