EN 60728-11:2017

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
4 Fundamental requirements
5 Protection against environmental influences
6 Equipotential bonding and earthing
7 Mains-supplied equipment
8 Remote power feeding in cable networks
9 Protection against contact and proximity to electric
   power distribution systems
10 System outlets and transfer points
11 Protection against atmospheric overvoltages
   and elimination of potential Differences
12 Mechanical stability
Annex A (informative) - Earth loop impedance
Annex B (informative) - Use of shield wires to protect
        installations with coaxial cables
Annex C (informative) - Differences in some countries
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications
Annex ZB (informative) - A-deviations
Annex ZC (normative) - Special national conditions

IEC 60728-11:2016 deals with the safety requirements applicable to fixed sited systems and equipment. As far as applicable, it is also valid for mobile and temporarily installed systems, for example, caravans. This fourth edition cancels and replaces the third edition published in 2010. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition:- Correction of minimum cross-section of bonding conductor in Figure 6, Figure 14 and Figure 17.- Creation of new symbols for "overvoltage protective device - (OPD)" and for "coaxial overvoltage protective device - (COPD)".- Introduction of new OPD symbol to 3.2, Figure 3 and Figure 6.- Introduction of new COPD symbol to 3.2 and Figure 19.- In 3.1 replacement of terms CATV, MATV and SMATV by new terms and definitions due to changes in technology and use of cable networks.- Extension for remote feeding voltage on subscriber feeder.- Adaption to Edition 2.0 of the IEC 62305 series.- Deletion of informative Annex C and normative reference to the simplified software for the calculation of risk due to lightning (Annex J of IEC 62305-2:2006.)- New subclause 10.2.6 Fully-isolated system outlet provided by means of a FTTH system.