EN 61010-2-033:2012

FOREWORD
INTRODUCTION
1 Scope and object
2 Normative references
3 Terms and definitions
4 Tests
5 Marking and documentation
6 Protection against electric shock
7 Protection against mechanical hazards
8 Resistance to mechanical stress
9 Protection against the spread of fire
10 Equipment temperature limits and resistance
    to heat
11 Protection against HAZARDS from fluids
12 Protection against radiation, including
    laser sources, and against sonic and ultrasonic
    pressure
13 Protection against liberated gases and
    substances, explosion and implosion
14 Components and subassemblies
15 Protection by interlocks
16 HAZARDS resulting from application
17 RISK assessment
101 Measuring circuits
Annexes
Annex K (normative) - Insulation requirements not
        covered by 6.7
Annex L (informative) - Index of defined terms
Annex AA (normative) - Measurement categories
Annex BB (informative) - Hazards pertaining to
         measurements performed in certain
         environments
Bibliography

IEC 61010-2-033:2012 specifies safety requirements for METERS. The METERS that have a primary purpose of measuring voltage on a live MAINS CIRCUIT are within the scope of this standard. They have various names, but all of them have capability for measurements of voltages on a live MAINS CIRCUIT. Some of the names given to this equipment are as follows: - MULTIMETER; - digital MULTIMETER; - VOLTMETER; - clamp METER (see also Part 2-032). For the purpose of this standard, the term METER is used for these HAND-HELD measuring instruments.