EN 61079-1:1993

FOREWORD
SECTION 1: GENERAL
  1.1 Scope and object
  1.2 Normative references
  1.3 Definitions
SECTION 2: GENERAL NOTES ON MEASUREMENTS
  2.1 General conditions
      2.1.1 Introduction
      2.1.2 Test site
      2.1.3 Environmental conditions
      2.1.4 Power supply
      2.1.5 Other conditions
  2.2 Radio-frequency input signals
      2.2.1 Introduction
      2.2.2 Test signals
      2.2.3 Test frequencies
      2.2.4 Radio-frequency input arrangement
      2.2.5 Input signal level
SECTION 3: MEASURING METHODS
  3.1 Polarization isolation
       3.1.1 Introduction
       3.1.2 Method of measurement
       3.1.3 Presentation of the results
  3.2 Impedance matching at the input terminal
       3.2.1 Introduction
       3.2.2 Method of measurement
       3.2.3 Presentation of the results
  3.3 Impedance matching at the output terminal
       3.3.1 Introduction
       3.3.2 Method of measurement
       3.3.3 Presentation of the results
  3.4 Gain frequency characteristics
       3.4.1 Introduction
       3.4.2 Method of measurement
       3.4.3 Presentation of the results
  3.5 Output signal level versus input signal level
       3.5.1 Introduction
       3.5.2 Method of measurement
       3.5.3 Presentation of the results
  3.6 Intermodulation
       3.6.1 Introduction
       3.6.2 Method of measurement
       3.6.3 Presentation of the results
  3.7 Noise figure and noise temperature
       3.7.1 Introduction
       3.7.2 Method of measurement
       3.7.3 Presentation of the results
  3.8 G/T
       3.8.1 Introduction
       3.8.2 Method of measurement
       3.8.3 Presentation of the results
  3.9 Alternative method for G/T
       3.9.1 Introduction
       3.9.2 Method of measurement
       3.9.3 Presentation of the results
  3.10 Image suppression ratio
       3.10.1 Introduction
       3.10.2 Method of measurement
       3.10.3 Presentation of the results
  3.11 Spurious responses
       3.11.1 Introduction
       3.11.2 Method of measurement
       3.11.3 Presentation of the results
  3.12 Intermediate frequency beat suppression ratio
       3.12.1 Introduction
       3.12.2 Method of measurement
       3.12.3 Presentation of the results
  3.13 Local oscillator frequency stability
       3.13.1 Introduction
       3.13.2 Method of measurement
       3.13.3 Presentation of the results
Figures
Annex A (informative) Bibliography
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications

Applies to the outdoor unit of a receiver for the direct reception of satellite broadcast transmissions in the 12 GHz band. Defines the conditions and methods of measurement to be applied.