EN 61169-38:2009

1 Scope
2 Normative references
3 Mating face and gauge information
  3.1 Dimensions - General connectors - Grade 2
      3.1.1 Connector with pin centre contact
      3.1.2 Connectors with socket-centre contact
  3.2 Gauges
      3.2.1 Connectors with pin-centre contact
      3.2.2 Connectors with socket-centre contact
  3.3 Dimensions - standard test connectors - Grade 0
      3.3.1 Connector with pin-centre contact
      3.3.2 Connector with socket-centre contact
  3.4 General requirements for connector mounting in
      modules and on panels
      3.4.1 Radial misalignment
      3.4.2 Axial misalignment
4 Quality assessment procedure
  4.1 General
  4.2 Rating and characteristics
  4.3 Test schedule and inspection requirements
      4.3.1 Acceptance tests
      4.3.2 Periodic tests
  4.4 Procedures
      4.4.1 Quality conformance inspection
      4.4.2 Qualification approval and its maintenance
5 Instructions for preparation of detail specifications
  5.1 General
  5.2 Identification of the detail specification
  5.3 Identification of the component
  5.4 Performance
  5.5 Marking, ordering information and related matters
  5.6 Selection of tests, test conditions and severities
  5.7 Blank detail specification pro-forma for type TMA
      connector
Annex ZA (normative) - Normative references to international
         publications with their corresponding European
         publications

IEC 61169-38:2008(E) which is a sectional specification, provides information and rules for the preparation of detail specifications for series TMA r.f. connectors together with the pro forma blank detail specification. Series TMA connectors have a characteristic impedance of 50 Ω and are normally used with R.F cables or with microstrip in microwave fields that has a blind-entry and middle low-power. The connectors are usable up to a frequency of at least 6 GHz.