EN 61180-2:1994

FOREWORD
1 Scope
2 Normative references
3 Definitions
4 General conditions for verification of test equipment
   4.1 Atmospheric conditions
   4.2 Connections and arrangement
   4.3 Influence of the load
   4.4 Comparison procedure
   4.5 Frequency of verifications
5 Verification of characteristics of direct voltage
   generators
   5.1 Ripple factor
   5.2 Permitted measuring error
   5.3 Voltage regulation
6 Verification of characteristics of alternating
   voltage generators
   6.1 Voltage wave-form
   6.2 Permitted measuring error
   6.3 Minimum test voltage
7 Verification of characteristics of impulse voltage
   generators
   7.1 Voltage wave-form
   7.2 Permitted measuring error
   7.3 Conventional output impedance
8 Verification of characteristics of impulse current
   generators
   8.1 Current wave-form
   8.2 Permitted measuring error
9 Verification of characteristics of hybrid impulse
   voltage generators
   9.1 Wave-form and permitted measuring error
   9.2 Virtual impedance
10 Requirements for reference measuring systems
   10.1 Direct voltage
   10.2 Alternating voltage
   10.3 Lightning impulse voltage
   10.4 Impulse current
   10.5 Comparative measurement
Annex A - Bibliography
ANNEX ZA (normative) OTHER INTERNATIONAL PUBLICATIONS
         QUOTED IN THIS STANDARD WITH THE REFERENCES OF THE
         RELEVANT EUROPEAN PUBLICATIONS

Applicable to the test equipment used for dielectric tests on low-voltage equipment. It covers tests with direct, alternating or impulse voltage, impulse current, and tests with a combination of impulse current.