EN 612:2005

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Shapes
   4.1 Gutters
       4.1.1 Components
       4.1.2 General requirements on the main parts
   4.2 Down-pipes
5 Classification
   5.1 Gutters
   5.2 Down-pipes
6 Material requirements
   6.1 Aluminium sheet
   6.2 Copper sheet
   6.3 Hot-dip metal coated steel sheet
   6.4 Metal plus organic coated steel sheet
   6.5 Stainless steel sheet
   6.6 Zinc sheet
7 Dimensional requirements
   7.1 Gutters
       7.1.1 Material thickness
       7.1.2 Tolerances
   7.2 Down-pipes
       7.2.1 Material thickness
       7.2.2 Tolerances
       7.2.3 Joints
   7.3 Accessories
8 Factory production control
9 Designation
10 Marking
11 Labelling

This document specifies requirements for eaves gutters and rainwater down-pipes made from metal sheet. It establishes the general characteristics, designation system, classification, marking and quality requirements for the products.The document applies to eaves gutters and external rainwater down-pipes that are supported by metal brackets and used to drain away rainwater. The shape and dimensions of a gutter are defined by the quantity of water to be drained away from the roof to the down-pipes and by architectural design requirements.The document specifies the requirements for gutters and rainwater down-pipes which enable these products to meet all usual service conditions such as catching and draining away rainwater, melted snow or ice water from a building to a drainage system or a sewer outside the building.Requirements for fixings, supporting construction, flashings or the method of making joints between the different components are not included in this document.This document does not specify requirements for tolerances on dimensions for eaves gutters handmade on site.