EN 62237:2005

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
   4.1 Protection against corrosion
   4.2 Finishing and mechanical protection
   4.3 Insulating parts
   4.4 Conductive parts
   4.5 Markings
   4.6 Instructions for use
5 Type tests
   5.1 General
       5.1.1 Preparation of test pieces
       5.1.2 Number of test pieces and test plan
   5.2 Visual inspection and dimensional check
       5.2.1 Visual inspection
       5.2.2 Dimensional check
   5.3 Electric tests
       5.3.1 Electric tests on insulating hoses
       5.3.2 Dielectric test on insulating hose with fittings
   5.4 Mechanical tests
       5.4.1 Hydrostatic test
       5.4.2 Fatigue test
       5.4.3 Mechanical impulse test
       5.4.4 Leakage test
       5.4.5 Change in length test
       5.4.6 Burst test
       5.4.7 Cold bend test
       5.4.8 Durability of marking
6 Quality assurance plan
7 Modifications
Annex A (normative) Suitable for live working; double triangle
                       (IEC-60417-5216(DB:2002-10))
Annex B (normative) Chronology of the tests
Annex C (normative) Quality assurance plan
Annex D (normative) Acceptance tests
Annex E (informative) In-service care
Annex ZA (normative) Normative references to international
                       Publications with their corresponding
                       European publications
Bibliography
Figures
Tables

Is applicable to mobile insulating hoses with fittings used with hydraulic tools and equipment for live working at nominal voltages exceeding 1 kV r.m.s. at power frequency. Insulating hoses with fittings are used to provide a connection between the hydraulic tool and the pump which are at different potentials. They are not considered as a fixed component of a live working device (e.g. aerial device). They can be connected and disconnected under negligible pressure. They can be directly handled by the user.