Skip to content
Please enter a keyword to search

  • EN 62384:2006/A1:2009

    View superseded by
    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    View superseded by

    DC OR AC SUPPLIED ELECTRONIC CONTROL GEAR FOR LED MODULES - PERFORMANCE REQUIREMENTS

    Available format(s): 

    Superseded date:  13-07-2020

    Language(s): 

    Published date:  12-01-2013

    Publisher:  European Committee for Standards - Electrical

    Pure ENs are not available for sale, please purchase a suitable national adoption

    Sorry this product is not available in your region.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    FOREWORD
    1 Scope
    2 Normative references
    3 Terms and definitions
    4 General notes on tests
    5 Classification
       5.1 Classification according to the load
       5.2 Classification according to the output voltage
       5.3 Classification according to the output current
    6 Marking
       6.1 Mandatory marking
       6.2 Optional marking
    7 Output voltage and current
       7.1 Starting and connecting requirements
       7.2 Voltage and current during operation
       7.3 Capacitive load requirement
       7.4 Voltage surges during switching and operation
    8 Total circuit power
    9 Circuit power factor
    10 Supply current
    11 Impedance at audio-frequencies
    12 Operational tests for abnormal conditions
    13 Endurance
    Annex A (normative) - Tests
    Annex B (informative) - A guide to quoting product life and
            failure rate
    Annex ZA (normative) - Normative references to international
             publications with their corresponding European
             publications
    Bibliography

    Abstract - (Show below) - (Hide below)

    Defines performance requirements for electronic control gear for use on d.c. supplies up to 250 V and a.c. supplies up to 1000 V at 50 Hz or 60 Hz with an output frequency which can deviate from the supply frequency, associated with LED modules according to IEC 62031.

    General Product Information - (Show below) - (Hide below)

    Committee TC 34
    Development Note To be used in conjunction with EN 61347-2-13. (12/2006) 2006 Edition Re-Issued in September 2009 & incorporates AMD 1 2009. (12/2009)
    Document Type Standard
    Publisher European Committee for Standards - Electrical
    Status Superseded
    Superseded By

    Standards Referenced By This Book - (Show below) - (Hide below)

    BS EN 13032-4:2015 Light and lighting. Measurement and presentation of photometric data of lamps and luminaires LED lamps, modules and luminaires
    EN 61347-2-13:2014/A1:2017 LAMP CONTROLGEAR - PART 2-13: PARTICULAR REQUIREMENTS FOR D.C. OR A.C. SUPPLIED ELECTRONIC CONTROLGEAR FOR LED MODULES
    EN 13032-4:2015 Light and lighting - Measurement and presentation of photometric data of lamps and luminaires - Part 4: LED lamps, modules and luminaires
    EN 62386-209 : 2011 DIGITAL ADDRESSABLE LIGHTING INTERFACE - PART 209: PARTICULAR REQUIREMENTS FOR CONTROL GEAR - COLOUR CONTROL (DEVICE TYPE 8)
    DIN EN 13032-4:2015-08 LIGHT AND LIGHTING - MEASUREMENT AND PRESENTATION OF PHOTOMETRIC DATA OF LAMPS AND LUMINAIRES - PART 4: LED LAMPS, MODULES AND LUMINAIRES
    16/30342256 DC : 0 BS EN 50107-3 - PRODUCT STANDARD COVERING LUMINOUS SIGNS WITH DISCHARGE LAMPS AND/OR LED (LIGHT EMITTING DIODES) AND/OR EL (ELECTROLUMINESCENT) LIGHTSOURCES WITH A NOMINAL VOLTAGE NOT EXCEEDING 1000 V, WITH THE EXCLUSION OF GENERAL LIGHTING, TRAFFIC- OR EMERGENCY RELATED PURPOSE
    BS EN 62442-3:2014 Energy performance of lamp controlgear Controlgear for halogen lamps and LED modules. Method of measurement to determine the efficiency of the controlgear
    13/30282207 DC : 0 BS EN 13032-4 - LIGHT AND LIGHTING - MEASUREMENT AND PRESENTATION OF PHOTOMETRIC DATA - PART 4: LED LAMPS, MODULES AND LUMINAIRES
    PREN 50107-3 : DRAFT 2016 PRODUCT STANDARD COVERING LUMINOUS SIGNS WITH DISCHARGE LAMPS AND/OR LED (LIGHT EMITTING DIODES) AND/OR EL (ELECTROLUMINESCENT) LIGHTSOURCES WITH A NOMINAL VOLTAGE NOT EXCEEDING 1000 V, WITH THE EXCLUSION OF GENERAL LIGHTING, TRAFFIC- OR EMERGENCY RELATED PURPOSE
    UNE-EN 61347-2-13:2015 Lamp controlgear - Part 2-13: Particular requirements for d.c. or a.c. supplied electronic controlgear for LED modules
    BS EN 62031 : 2008 LED MODULES FOR GENERAL LIGHTING - SAFETY SPECIFICATIONS
    BS EN 62386-209:2011 Digital addressable lighting interface Particular requirements for control gear. Colour control (device type 8)
    DIN EN 13032-4 E : 2015 LIGHT AND LIGHTING - MEASUREMENT AND PRESENTATION OF PHOTOMETRIC DATA OF LAMPS AND LUMINAIRES - PART 4: LED LAMPS, MODULES AND LUMINAIRES
    BS EN 61347-2-13 : 2014 LAMP CONTROLGEAR - PART 2-13: PARTICULAR REQUIREMENTS FOR D.C. OR A.C. SUPPLIED ELECTRONIC CONTROLGEAR FOR LED MODULES (IEC 61347-2-13:2014)
    EN 62031:2008/A2:2015 LED MODULES FOR GENERAL LIGHTING - SAFETY SPECIFICATIONS (IEC 62031:2008/A2:2014)
    UNE-EN 13032-4:2016 Light and lighting - Measurement and presentation of photometric data of lamps and luminaires - Part 4: LED lamps, modules and luminaires
    I.S. EN 13032-4:2015 LIGHT AND LIGHTING - LIGHT AND LIGHTING - MEASUREMENT AND PRESENTATION OF PHOTOMETRIC DATA OF LAMPS AND LUMINAIRES - PART 4: LED LAMPS, MODULES AND LUMINAIRES
    EN 62442-3:2014/A11:2017 ENERGY PERFORMANCE OF LAMP CONTROLGEAR - PART 3: CONTROLGEAR FOR HALOGEN LAMPS AND LED MODULES - METHOD OF MEASUREMENT TO DETERMINE THE EFFICIENCY OF THE CONTROLGEAR
    I.S. EN 61347-2-13:2014 LAMP CONTROLGEAR - PART 2-13: PARTICULAR REQUIREMENTS FOR D.C. OR A.C. SUPPLIED ELECTRONIC CONTROLGEAR FOR LED MODULES

    Standards Referencing This Book - (Show below) - (Hide below)

    IEC 61547:2009 Equipment for general lighting purposes - EMC immunity requirements
    IEC 61347-2-13:2014+AMD1:2016 CSV Lamp controlgear - Part 2-13: Particular requirements for d.c. ora.c. supplied electronic controlgear for LED modules
    EN 61347-2-13:2014/A1:2017 LAMP CONTROLGEAR - PART 2-13: PARTICULAR REQUIREMENTS FOR D.C. OR A.C. SUPPLIED ELECTRONIC CONTROLGEAR FOR LED MODULES
    IEC 60410:1973 Sampling plans and procedures for inspection by attributes
    EN 61000-3-2:2014 Electromagnetic compatibility (EMC) - Part 3-2: Limits - Limits for harmonic current emissions (equipment input current ≤ 16 A per phase)
    EN 61547:2009 Equipment for general lighting purposes - EMC immunity requirements
    IEC 62031:2008+AMD1:2012+AMD2:2014 CSV LED MODULES FOR GENERAL LIGHTING - SAFETY SPECIFICATIONS
    IEC 61000-3-2 : 4.0 ELECTROMAGNETIC COMPATIBILITY (EMC) - PART 3-2: LIMITS - LIMITS FOR HARMONIC CURRENT EMISSIONS (EQUIPMENT INPUT CURRENT <= 16 A PER PHASE)
    View more information

    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective