EN IEC 63093-7:2018

FOREWORD
1 Scope
2 Normative references
3 Terms and definitions
4 Primary dimensions
5 Limits of surface irregularities
Annex A (normative) - Derived standards
Annex B (normative) - Example of dimensions for gauges
        to check the dimensions of EER-cores meeting this
        primary standard
Annex C (informative) - Examples of allowable areas of
        chips
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

IEC63093-7:2018(E) specifies the dimensions that are of importance for mechanical interchangeability for a preferred range of EER-cores made of ferrite, the essential dimensions of coil formers to be used with them as well the effective parameter values to be used in calculations involving them, and gives guidelines on allowable limits of surface irregularities applicable to EER-cores.This document is a specification useful in the negotiations between ferrite core manufacturers and customers about surface irregularities.The use of “derived” standards which give more detailed specifications of component parts while still permitting compliance with this document is discussed in Annex A.This first edition cancels and replaces the first edition of IEC62317-7 published in 2005. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to IEC62317-7:a) IEC63093-7 integrates IEC62317-7 and IEC60424-3;b) IEC60424-3:2015, Table 2, has been included in Annex C as Table C.1.