EN ISO 14120:2015

European foreword
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Risk assessment
5 General requirements for the design and
  construction of guards
6 Selection of types of guards
7 Verification of the safety requirements for guards
8 Information for use
Annex A (informative) - Example of retained fastening
Annex B (informative) - Example of projectile test method
        for mechanically testing guards
Annex C (informative) - Example of pendulum test method
        for mechanically testing guards
Annex D (informative) - Relationship between International
        Standards referenced in Clause 2 and corresponding
        European Standards
Bibliography
Annex ZA (informative) - Relationship between this
         European Standard and the Essential
         Requirements of EU Directive 2006/42/EC

ISO 14120:2015 specifies general requirements for the design, construction, and selection of guards provided to protect persons from mechanical hazards.ISO 14120:2015 indicates other hazards that can influence the design and construction of guards.ISO 14120:2015 applies to guards for machinery which will be manufactured after it is published.The requirements are applicable if fixed and movable guards are used. This International Standard does not cover interlocking devices. These are covered in ISO 14119.ISO 14120:2015 does not provide requirements for special systems relating specifically to mobility such as ROPS (rollover protective structures), FOPS (falling-object protective structures), and TOPS (tip over protective structures) or to the ability of machinery to lift loads.