EN ISO 15653:2018

European foreword
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and units
5 Principle
6 Choice of specimen design, specimen orientation
   and notch location
7 Pre-machining metallography
8 Machining
9 Specimen preparation
10 Test apparatus, requirements and test procedure
11 Post-test metallography
12 Post-test analysis
13 Test report
Annex A (informative) - Examples of notch locations
Annex B (informative) - Examples of pre-test and post-test
        metallography
Annex C (informative) - Residual-stress modification and
        precracking technique
Annex D (normative) - Assessment of pop-in
Annex E (informative) - Shallow-notched bend specimen testing
Bibliography

ISO 15653:2018 specifies methods for determining fracture toughness in terms of stress intensity factor (K), crack tip opening displacement or CTOD (δ) and experimental equivalent of the J-integral for welds in metallic materials (J).ISO 15653:2018 complements ISO 12135, which covers all aspects of fracture toughness testing of parent metal and which needs to be used in conjunction with this document. This document describes methods for determining point values of fracture toughness. It should not be considered a way of obtaining a valid R-curve (resistance-to-crack-extension curve). However, the specimen preparation methods described in this document could be usefully employed when determining R-curves for welds. The methods use fatigue precracked specimens which have been notched, after welding, in a specific target area in the weld. Methods are described to evaluate the suitability of a weld for notch placement within the target area, which is either within the weld metal or within the weld heat-affected zone (HAZ), and then, where appropriate, to evaluate the effectiveness of the fatigue crack in sampling these areas.