EN ISO 17657-2:2007

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Physical environment and operating conditions
5 Classification of welding current meters with
  their current sensing coil, and designation
  of product
  5.1 Classes of welding current meter with
       current sensing coil
  5.2 Designation of product
6 Requirements for welding current meter with
  current sensing coil
  6.1 Welding current meter
  6.2 Current sensing coil
  6.3 Welding current meter with its current
       sensing coil
  6.4 Integrator
  6.5 Data processing unit
  6.6 Display unit and output ports
  6.7 Minimum and maximum duration of welding current
  6.8 Maximum measuring current
  6.9 Minimum measuring current
  6.10 Phase-controlled current
  6.11 Minimum time for current measurement
  6.12 Fluctuation of supply voltage
  6.13 Mechanical strength of current sensing coil
  6.14 Setting position error of current sensing coil
  6.15 Influence of ambient temperature
  6.16 Test
       6.16.1 Type test
       6.16.2 Acceptance test
7 Test procedures
  7.1 Maximum measuring current
  7.2 Minimum measuring current
  7.3 Phase-controlled current
  7.4 Minimum time for current measurement
  7.5 Fluctuation of supply voltage
  7.6 Thermal test
8 Marking
Annex A (normative) Definition of indicated measuring
        time and its indicated current value
      A.1 Indicated measuring time
      A.2 Welding current value for the indicated
          measuring time
Annex B (informative) Set-up of a current sensing coil
        and construction of welding current meters

ISO 17657-2:2005 specifies a welding current meter with a current sensing coil to measure the weld time and the r.m.s. value of the welding current during a certain interval using single phase alternating current of frequency of 50 Hz or 60 Hz, or direct current.