EN ISO 8099-1:2018
Current
The latest, up-to-date edition.
Small craft - Waste systems - Part 1: Waste water retention (ISO 8099-1:2018)
28-02-2018
European foreword
Foreword
1 Scope
2 Normative reference
3 Terms and definitions
4 General requirements
5 Materials
6 Plumbing system
7 Vent system
8 Holding tanks
9 Pump-out fitting
10 Identification
11 Information for owner's manual
Annex A (normative) - Nominal design of
pump-out fitting
Annex B (informative) - Typical installations
for toilet retention systems
Annex ZA (informative) - Relationship between this
European Standard and the Essential
Requirements of Directive 2013/53/EU
aimed to be covered
ISO 8099-1:2018 specifies requirements for the design, construction and installation of systems for temporary retention of sewage for subsequent disposal. It applies to small craft with a length of hull (LH) of up to 24 m.ISO 8099-1:2018 does not address waste water treatment systems.
| Committee |
CEN/TC 464
|
| DevelopmentNote |
Supersedes EN ISO 8099. (03/2018)
|
| DocumentType |
Standard
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Current
|
| Supersedes |
| Standards | Relationship |
| DS/EN ISO 8099-1:2018 | Identical |
| ONORM EN ISO 8099-1 : 2018 | Identical |
| SS-EN ISO 8099-1:2018 | Identical |
| NEN EN ISO 8099-1 : 2018 | Identical |
| DIN EN ISO 8099-1:2018-05 | Identical |
| PN-EN ISO 8099-1:2018-04 | Identical |
| NF EN ISO 8099-1:2018 | Identical |
| ISO 8099-1:2018 | Identical |
| I.S. EN ISO 8099-1:2018 | Identical |
| BS EN ISO 8099-1:2018 | Identical |
| NS EN ISO 8099-1 : 2018 | Identical |
| UNE-EN ISO 8099-1:2018 | Identical |
| ISO 10133:2012 | Small craft — Electrical systems — Extra-low-voltage d.c. installations |
| ISO 9093-2:2002 | Small craft — Seacocks and through-hull fittings — Part 2: Non-metallic |
| ISO 13297:2014 | Small craft — Electrical systems — Alternating current installations |
| ISO 9093-1:1994 | Small craft — Seacocks and through-hull fittings — Part 1: Metallic |
| ISO 228-1:2000 | Pipe threads where pressure-tight joints are not made on the threads — Part 1: Dimensions, tolerances and designation |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.