ETS 300 135 : 20001

Foreword
Introduction
1 Scope
2 Normative references
3 Definition, abbreviations and symbols
  3.1 Definitions
  3.2 Abbreviations
  3.3 Symbols
4 General
  4.1 Presentation of equipment for testing purposes
  4.2 Mechanical and electrical design
  4.3 Interpretation of the measurement results
5 Technical characteristics
  5.1 Common characteristics
  5.2 Transmitter parameter limits
  5.3 Receiver parameter limits
6 Test conditions, power sources and ambient
  temperatures
  6.1 Normal and extreme test conditions
  6.2 Test power source
  6.3 Normal test conditions
  6.4 Extreme test conditions
  6.5 Procedure for tests at extreme temperatures
7 General conditions
  7.1 Arrangements for test signals applied to the
      receiver input
  7.2 Receiver mute or squelch facility
  7.3 Receiver rated audio output power
  7.4 Normal test modulation
  7.5 Artificial antenna
  7.6 Test fixture
  7.7 Arrangement for test signals at the input of the
      transmitter
  7.8 Test site and general arrangements for radiated
      measurements
8 Method of measurement for transmitter parameters
  8.1 Frequency error
  8.2 Transmitter carrier power
  8.3 Maximum frequency deviation
  8.4 Unwanted amplitude modulation
  8.5 Adjacent channel power
  8.6 Spurious emissions
  8.7 Transient frequency behaviour of the transmitter
9 Methods of measurement for receiver parameters
  9.1 Maximum usable sensitivity
  9.2 Adjacent channel selectivity
  9.3 Intermodulation response rejection
10 Measurement uncertainty
Annex A: Radiated measurement
  A.1 Test sites and general arrangements for
      measurements involving the use of radiated fields
  A.2 Guidance on the use of radiation test sites
  A.3 Further optional alternative indoor test site
      using an anechoic chamber
Annex B: Specification for adjacent channel power
measurement arrangements
  B.1 Power measuring receiver specification
History

Covers the minimum characteristics that are needed in order to make the best use of the available frequencies. It does not necessarily represent the optimum performance achievable, nor does it necessarily include all the characteristics which may be required by a user. Applies to equipment with an integral antenna and to equipment with a socket for external antenna.