ETS 300 384 : 20001

Foreword
1 Scope
2 Normative references
3 Definitions and abbreviation
  3.1 Definitions
  3.2 Abbreviations
4 Technical requirements
  4.1 Characteristics of RF interface ports
  4.2 Transmitter input configuration
  4.3 Transmitter output characteristics
  4.4 Frequency range
  4.5 Frequency stability
  4.6 Frequency adjustment
  4.7 Unwanted frequency shift
  4.8 Frequency deviation
  4.9 Overdeviation
  4.10 Deviation sensitivity stability
  4.11 Unwanted emissions
  4.12 Amplitude Modulation (AM)
  4.13 Test load characteristics
5 Operating and test conditions
  5.1 Normal operating and test conditions
  5.2 Extreme operating and test conditions
Annex A (normative): Stereo test encoder for pilot
        tone system, audio and multiplex parameters
  A.1 Introduction
  A.2 Input parameters
  A.3 Pilot signal
  A.4 Output
  A.5 Non linear distortion
  A.6 Signal to Noise ratio (S/N)
  A.7 Linear distortion
  A.8 Linear crosstalk
Annex B (normative): RF Spectrum measurements to
        detect excessive spectrum pollution due to
        abnormal AF - input levels
  B.1 Measuring arrangement
  B.2 Measuring procedure
  B.3 Presentation of the results
Annex C (informative): General conditions of operation
  C.1 Temperature in the operating room
  C.2 Relative humidity in the operating room
  C.3 Cooling air temperature
  C.4 Relative humidity of the air entering the cooling
      system up to 25 degree C
  C.5 Air pressure
  C.6 Immunity against mechanical vibrations airborne
      or air pressure
  C.7 Immunity against electric field strength within
      the broadcasting bands
  C.8 Immunity against magnetic field strength
  C.9 Mains voltage
  C.10 Mains frequency
Annex D (normative): Reverse intermodulation
        measurements
  D.1 Scope of annex
  D.2 Measurement arrangement
  D.3 Principle of measurement
  D.4 Measurement routine
Annex E (informative): Bibliography
History