ETS 300 433 : 20001

Introduction
1 Scope
2 Normative references
3 Definitions, abbreviations and symbols
  3.1 Definitions
  3.2 Abbreviations
  3.3 Symbols
4 General
  4.1 Presentation of equipment for testing purposes
  4.2 Mechanical and electrical design
  4.3 Interpretation of the measurement results
5 Technical characteristics
  5.1 Common characteristics
  5.2 Transmitter parameter limits
  5.3 Receiver parameter limits
6 Test conditions, power sources and ambient
  temperatures
  6.1 Normal and extreme test conditions
  6.2 Test power source
  6.3 Normal test conditions
  6.4 Extreme test conditions
  6.5 Procedure for tests at extreme temperatures
7 General conditions
  7.1 Arrangements for test signals applied to the
      receiver input
  7.2 Receiver mute or squelch facility
  7.3 Receiver rated audio output power
  7.4 Transmitter rated RF power
  7.5 Normal test modulation
  7.6 Artificial antenna
  7.7 Test fixture
  7.8 Arrangement for test signals at the input of the
      transmitter
  7.9 Test site and general arrangements for radiated
      measurements
8 Method of measurement for transmitter parameters
  8.1 Frequency error
  8.2 Transmitter RF power
  8.3 Adjacent channel power
  8.4 Spurious emissions
  8.5 Transient frequency behaviour of the transmitter
9 Methods of measurement for receiver parameters
  9.1 Maximum usable sensitivity
  9.2 Adjacent channel selectivity
  9.3 Inter-modulation response rejection
  9.4 Spurious radiation
  9.5 Spurious response rejection
10 Measurement uncertainty
Annex A (normative): Radiated measurement
  A.1 Test sites and general arrangements for
      measurements involving the use of radiated
      fields
  A.2 Guidance on the use of radiation test sites
  A.3 Further optional alternative indoor test site
      using an anechoic chamber
Annex B (normative): Specification for adjacent
        channel power measurement arrangements
  B.1 Power measuring receiver specification
History

IW (carrier power) DSB AM & 4W (PEP) SSB AM