I.S. CEN TS 14578:2003
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
PLASTICS PIPING SYSTEMS FOR WATER SUPPLY OR DRAINAGE AND SEWERAGE - GLASS-REINFORCED THERMOSETTING PLASTICS (GPR) BASED ON UNSATURATED POLYESTER RESIN (UP) - RECOMMENDED PRACTICE FOR INSTALLATION
Hardcopy , PDF
22-12-2013
English
01-01-2003
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Procedures
4.1 General
4.2 Special conditions for pipe having a nominal
stiffness less than SN 1250
5 Specific information and recommendations
5.1 General
5.2 Specific transportation requirements
5.3 Maximum storage heights on site
5.4 Maximum storage period in direct sunlight
5.5 Any climatic conditions requiring special storage
5.6 Limiting deflections
5.7 Coefficient of linear expansion
5.8 Longitudinal tensile modulus and strength
5.9 Suitability for use in areas exposed to sunlight
5.10 Appropriate jointing system
5.11 Cold bending
5.12 Permitted rates of loss of water and/or pressure
Bibliography
Provides recommended practices for installing piping systems made of glass-reinforced thermosetting plastics based on unsaturated polyester resin (GRP-UP), intended to be used for pressure or non-pressure water or sewerage applications.
| DevelopmentNote |
Supersedes I.S. EN 1636-6 (12/2003)
|
| DocumentType |
Standard
|
| Pages |
10
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| CEN/TS 14578:2013 | Identical |
| PREN 14364 : DRAFT 2011 | PLASTICS PIPING SYSTEMS FOR DRAINAGE AND SEWERAGE WITH OR WITHOUT PRESSURE - GLASS-REINFORCED THERMOSETTING PLASTICS (GRP) BASED ON UNSATURATED POLYESTER RESIN (UP) - SPECIFICATIONS FOR PIPES, FITTINGS AND JOINTS |
| EN 1636-6 : 1997 | PLASTICS PIPING SYSTEMS FOR NON-PRESSURE DRAINAGE AND SEWERAGE - GLASS-REINFORCED THERMOSETTING PLASTICS (GRP) BASED ON UNSATURATED POLYESTER RESIN (UP) - PRACTICES FOR INSTALLATION |
| PREN 1796 : DRAFT 2011 | PLASTICS PIPING SYSTEMS FOR WATER SUPPLY WITH OR WITHOUT PRESSURE - GLASS-REINFORCED THERMOSETTING PLASTICS (GRP) BASED ON UNSATURATED POLYESTER RESIN (UP) |
| EN 1610:2015 | Construction and testing of drains and sewers |
| ENV 1046:2001 | Plastics piping and ducting systems - Systems outside building structures for the conveyance of water or sewage - Practices for installation above and below ground |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.