I.S. EN 1090-2:2018
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Execution of steel structures and aluminium structures - Part 2: Technical requirements for steel structures
Hardcopy , PDF
09-05-2024
English
08-07-2018
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
Important note : Users cannot be edited or removed once added to your Multi user PDF.
European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Specifications and documentation
5 Constituent products
6 Preparation and assembly
7 Welding
8 Mechanical fastening
9 Erection
11 Geometrical tolerances
12 Inspection, testing and correction
Annex A (normative) Additional information, options and requirements related to the execution classes
Annex B (normative) Geometrical tolerances
Annex C (informative) Check-list for the content of a quality plan
Annex D (informative) Procedure for checking capability of automated thermal cutting processes
Annex E (informative) Welded joints in hollow sections
Annex F (normative) Corrosion protection
Annex G (normative) Determination of slip factor
Annex H (normative) Calibration test for preloaded bolting assemblies under site conditions
Annex I (informative) Determination of loss of preload for thick surface coatings
Annex J (informative) Resin injection bolts
Annex K (informative) Guide to flow diagram for development and use of a WPS
Annex L (informative) Guidance on the selection of weld inspection classes
Annex M (normative) Sequential method for fasteners inspection
Bibliography
This European Standard specifies requirements for execution of structural steelwork as structures or as manufactured components, produced from: — hot rolled, structural steel products up to and including grade S700; — cold formed components and sheeting up to and including grade S700 (unless coming within the scope of EN 1090-4); — hot finished or cold formed austenitic, austenitic-ferritic and ferritic stainless steel products; — hot finished or cold formed structural hollow sections, including standard range and custom-made rolled products and hollow sections manufactured by welding.
| Committee |
TC 135
|
| DocumentType |
Standard
|
| Pages |
210
|
| ProductNote |
The date of any NSAI previous adoption may not match the date of its original CEN/CENELEC document.
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| EN 1090-2:2018 | Identical |
| EN 1090-2:2008+A1:2011 | Identical |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.