I.S. EN 12814-4:2002
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
TESTING OF WELDED JOINTS OF THERMOPLASTICS SEMI-FINISHED PRODUCTS - PART 4: PEEL TEST
Hardcopy , PDF
29-04-2018
English
01-01-2002
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
National Foreword
European foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and designations
5 T-peel test
6 Decohesion test
7 Crush test
8 Test report
Bibliography
Defines the dimensions, the method of sampling and the preparation of the test specimens, and also the conditions for performing the peel test perpendicular to the weld in order to determine the peel resistance and the failure behaviour.
| DocumentType |
Standard
|
| Pages |
18
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| Standards | Relationship |
| SN EN 12814-4 : 2001 | Identical |
| DIN EN 12814-4:2001-12 | Identical |
| UNI EN 12814-4 : 2003 | Identical |
| NS EN 12814-4 : 1ED 2001 | Identical |
| UNE-EN 12814-4:2002 | Identical |
| NBN EN 12814-4 : 2001 | Identical |
| BS EN 12814-4:2001 | Identical |
| ONORM EN 12814-4 : 2003 | Identical |
| NF EN 12814-4 : 2002 | Identical |
| EN 12814-4:2018 | Identical |
| NEN EN 12814-4 : 2018 | Identical |
| EN 1555-3:2010+A1:2012 | Plastics piping systems for the supply of gaseous fuels - Polyethylene (PE) - Part 3: Fittings |
| EN 12201-3:2011+A1:2012 | Plastics piping systems for water supply, and for drainage and sewerage under pressure - Polyethylene (PE) - Part 3: Fittings |
| CEN/TS 16892:2015 | Plastics - Welding of thermoplastics - Specification of welding procedures |
| EN 14728:2005 | Imperfections in thermoplastic welds - Classification |
| ISO 13954:1997 | Plastics pipes and fittings Peel decohesion test for polyethylene (PE) electrofusion assemblies of nominal outside diameter greater than or equal to 90 mm |
| ISO 13955:1997 | Plastics pipes and fittings — Crushing decohesion test for polyethylene (PE) electrofusion assemblies |
| ISO 5893:2002 | Rubber and plastics test equipment Tensile, flexural and compression types (constant rate of traverse) Specification |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.