I.S. EN 12899-1:2007

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
4 Retroreflective sign face material
   4.1 Glass bead material
   4.2 Microprismatic material
5 Structural performance
   5.1 General
   5.2 Partial safety factors
   5.3 Loads
   5.4 Deflections
6 Supports
   6.1 Tops
   6.2 Base compartments
   6.3 Performance under vehicle impact
   6.4 Corrosion resistance
   6.5 Base plates
7 Sign plates, sign faces, transilluminated signs, externally
   illuminated signs and supports
   7.1 Design
   7.2 Sign faces
   7.3 Transilluminated signs
   7.4 Externally illuminated signs
8 Sign assemblies
9 Marking, labelling and product information
   9.1 General
   9.2 Marking and labelling
   9.3 Product information
   9.4 Luminaires
10 Evaluation of conformity
11 Dangerous substances
Annex A (normative) Test points for horizontal and vertical loads
      A.1 Wind load
      A.2 Snow clearance, dynamic load, load combination
Annex ZA (informative) Clauses of this European Standard addressing
         the provisions of the EU Construction Products Directive
      ZA.1 Scope and relevant characteristics
      ZA.2 Procedure for attestation of conformity of fixed
           vertical road traffic signs
      ZA.3 CE marking and labelling

Describes requirements for complete sign assemblies including supports), signs (sign plates with sign faces), sign plates (without sign faces) and for other major components (retroreflective sheeting, supports and luminaires).