I.S. EN 13063-3:2007

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Shapes, dimensions and tolerances
   4.1 Air-flue system chimney
   4.2 Terminals
   4.3 Pressure-equalising openings
   4.4 Air duct dimensions
5 Requirements
   5.1 General
   5.2 Material requirements for air-flue system chimneys
        and terminals
   5.3 Minimum compressive strength for a pressure-equalising
        opening section
   5.4 Outer wall elements
   5.5 Safety in use
        5.5.1 Thermal resistance
        5.5.2 Thermal resistance of the flue duct (concentric)
        5.5.3 Thermal resistance of the flue duct (side by side)
        5.5.4 Thermal resistance of the air duct
   5.6 Resistance to fire external to external
   5.7 Aerodynamic requirements
        5.7.1 Flow resistance of air ducts
        5.7.2 Aerodynamic properties of terminals
        5.7.3 Pressure-equalising opening section
6 Replacement of single components of the air flue
   system chimney
7 Designation
8 Product information
9 Marking and labelling
10 Evaluation of conformity
   10.1 General
   10.2 Initial type testing
   10.3 Evaluation of conformity for the exchange of
        components
   10.4 Factory production control
Annex A (normative) Test methods
   A.1 Compressive strength of pressure-equalising opening
        sections
        A.1.1 Test sample
        A.1.2 Testing equipment
        A.1.3 Test procedure
   A.2 Aerodynamic behaviour of terminals under wind conditions
        A.2.1 Test apparatus
        A.2.2 Test sample
        A.2.3 Measuring parameters
        A.2.4 Test procedure
        A.2.5 Test results
Annex ZA (informative) Clauses of this European Standard
                          addressing the provisions of the
                          EU Construction Products Directive
        ZA.1 Scope and relevant characteristics
        ZA.2 Procedure(s) for attestation of conformity of
               systems chimneys with clay/ceramic flue liners
               ZA.2.1 System(s) of attestation of conformity
               ZA.2.2 EC Certificate and Declaration of conformity
        ZA.3 CE marking and labelling
Bibliography

Defines the requirements and test methods for dry (designated D) and/or wet (designated W) air flue system chimneys, including terminals in which the products of combustion are conveyed to the atmosphere through clay/ceramic flue liners and combustion air is conveyed to suitable room-sealed appliances through an air duct or an air gap.