I.S. EN 13090:2001

Foreword
Introduction
1 Scope
2 Normative References
3 Terms and definitions
4 Requirements
   4.1 Requirements to be met by the sealant as
        received
        4.1.1 Effect on metals
        4.1.2 Effect on seals
        4.1.3 Effect on combustion behaviour of
               fuel gases
   4.2 Requirements to be met by the sealant after
        assembly
        4.2.1 Sealing properties
               4.2.1.1 Effect of gas condensate
                        on sealants
               4.2.1.2 Effect of vibration
        4.2.2 Disassembly of joints
5 Test material and documentation
   5.1 Test material
   5.2 Documentation
6 Test methods
   6.1 Test of sealants as received
        6.1.1 Test of corrosiveness
        6.1.2 Test of effect on seals
        6.1.3 Test of effect on the combustion
               behaviour of fuel gases
   6.2 Test of sealants in test assemblies
        6.2.1 Test of sealing properties
               6.2.1.1 Preparation of test
                        assemblies
               6.2.1.2 Sealing
               6.2.1.3 Soundness test
               6.2.1.4 Aging test
               6.2.1.5 Test of resistance against
                        gas condensate
               6.2.1.6 Test of vibration resistance
        6.2.2 Dismantling
7 Marking
Annex A (informative) A-deviations

Covers the properties and the test methods of sealants used to reseal threaded joints of metallic gas pipework in buildings operated at a maximum allowed operating pressure of 100 mbar.