Foreword
1 Scope
2 Normative references
3 Terms, definitions, symbols, units and abbreviated
terms
3.1 Terms and definitions
3.2 Symbols, units and abbreviated terms
4 Requirements
4.1 General
4.2 Thermal resistance
4.3 Mechanical resistance and stability of the system
4.3.1 Bond strength of the base coat to the MW board
4.3.2 Bond strength of the adhesive to the MW board
for ETICS fixed by an adhesive
4.3.3 Pull-off resistance of the ETICS fixed by
mechanical fixing
4.4 Reaction to fire
4.5 MW boards
4.6 Tensile strength of the reinforcement
4.7 Liquid water permeability of the system surface
4.8 Resistance to impact
4.9 Resistance to penetration
4.10 Water vapour permeability
4.11 Durability and adhesion of the finishing material
on the base coat
5 Test methods
5.1 Sampling
5.2 Conditioning
5.2.1 Conditioning of the test specimen for the
determination of the tensile bond strength
of the adhesive to the thermal insulation
material
5.2.2 Conditioning of the test specimen in
accordance with EN 1062-11 for the
determination of the tensile bond strength
of the base coat to the thermal insulation
material, liquid water permeability of the
system surface, resistance to impact,
resistance to penetration, water vapour
permeability, durability and adhesion of the
finishing material on the base coat
5.3 Testing
6 Designation code
7 Evaluation of conformity
8 Marking and labelling
8.1 The entire and specific information of all
components of the kit has to be given on an
accompanying document that contains:
8.2 Components conforming to this standard shall be
clearly marked, either on the product or on the
label with the following information:
8.3 Additional information:
8.3.1 Reinforcement
8.3.2 Adhesive
8.3.3 Base coat
8.3.4 Finishing coat
8.3.5 MW-Boards
8.3.6 Rails
8.3.7 Anchors
Annex A (normative) Factory production control
Annex B (informative) Additional information for customer
and designers
B.1 Resistance of the systems surface to cracking
Bibliography