I.S. EN 14636-1:2009
Current
The latest, up-to-date edition.
PLASTICS PIPING SYSTEMS FOR NON-PRESSURE DRAINAGE AND SEWERAGE - POLYESTER RESIN CONCRETE (PRC) - PART 1: PIPES AND FITTINGS WITH FLEXIBLE JOINTS
Hardcopy , PDF
English
01-01-2009
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Foreword
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
4 General requirements
5 Pipes
6 Fittings
7 Joint performance
8 Dangerous substances
9 Manufacturer's installation recommendations
10 Evaluation of conformity
Annex A (normative) - Determination of a pipe's crushing
strength and ring bending tensile
strength using a pipe test piece
Annex B (normative) - Determination of a pipe's crushing
strength or the ring bending tensile
strength using test pieces sawn from
a pipe
Annex C (normative) - Assessment of longitudinal bending
moment resistance (BMR)
Annex D (normative) - Determination of the compressive
strength of polyester resin concrete
(PRC) using test pieces which are cut
from a pipe
Annex E (normative) - Determination of the fatigue strength
of a pipe under cyclic loading
Annex F (normative) - Assessment of the leak-tightness of a
pipe and its joints under short term
exposure to internal water pressure
Annex G (normative) - Determination of the long-term crushing
strength of a pipe, including the effects
of media attack, using the 50 years
reference point
Bibliography
Pertains to pipes and fittings made from polyester resin concrete, intended to be used within a drain or sewer system operating without pressure.
| DocumentType |
Standard
|
| Pages |
82
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Current
|
| Standards | Relationship |
| EN 14636-1:2009 | Identical |
| EN ISO 3126:2005 | Plastics piping systems - Plastics components - Determination of dimensions (ISO 3126:2005) |
| EN 13121-1:2003 | GRP tanks and vessels for use above ground - Part 1: Raw materials - Specification conditions and acceptance conditions |
| ISO 75-2:2013 | Plastics — Determination of temperature of deflection under load — Part 2: Plastics and ebonite |
| EN ISO 75-2:2013 | Plastics - Determination of temperature of deflection under load - Part 2: Plastics and ebonite (ISO 75-2:2013) |
| ISO 3126:2005 | Plastics piping systems Plastics components Determination of dimensions |
| EN 476:2011 | General requirements for components used in drains and sewers |
| EN ISO 9001:2015 | Quality management systems - Requirements (ISO 9001:2015) |
| ISO 9001:2015 | Quality management systems — Requirements |
| EN 1119:2009 | Plastics piping systems - Joints for glass-reinforced thermosetting plastics (GRP) pipes and fittings - Test methods for leaktightness and resistance to damage of non-thrust resistant flexible joints with elastomeric sealing elements |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.