I.S. EN 15088:2006

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
  4.1 Ordering Information
  4.2 Selection of alloy and temper
  4.3 Product requirements
5 Evaluation of conformity
  5.1 General
  5.2 Testing
  5.3 Factory production control (FPC)
  5.4 One-off products, prototypes and products
       produced in very small quantities
6 Marking, labelling and packaging
Annex A (normative) Fatigue testing and design
                     of extruded, rolled or forged
                     products
  A.1 General
  A.2 Fatigue testing of the constituent
       material (extruded, rolled or forged
       products)
  A.3 Test piece for fatigue testing
  A.4 Design code
Annex B (normative) Bendability
  B.1 General
  B.2 Bendability classes
  B.3 Assignment to standardized tempers of
       semi-finished products
Annex ZA (informative) Clauses of this European Standard
                       addressing the provisions of EU
                       Construction Products Directive CPD -
                       EU Directive 89/106/EEC
  ZA.1 Scope and relevant characteristics
  ZA.2 Procedures for the attestation of
       conformity of structural metallic
       construction products
  ZA.3 CE marking and labelling
Bibliography

Describes the requirements for semi-finished products and castings of aluminium and aluminium alloys for load-bearing structural construction works (Construction works covers building and civil engineering works).