I.S. EN 1758:1998

Foreword
1 Scope
2 Normative references
3 Definitions
   3.1 strip
   3.2 lead frame
4 Designations
   4.1 Material
   4.2 Material condition
   4.3 Product
5 Ordering information
6 Requirements
   6.1 Composition
   6.2 Mechanical properties
   6.3 Technological properties
   6.4 Dimensions and tolerances
   6.5 Form tolerances
   6.6 Surface properties
   6.7 Edge stress
   6.8 Electrical conductivity
7 Sampling
   7.1 General
   7.2 Analysis
   7.3 Mechanical and other tests
8 Test methods
   8.1 Analysis
   8.2 Tensile test
   8.3 Hardness test
   8.4 Bend test
   8.5 Edge burr b
   8.6 Coil set
   8.7 Transverse cross bow q
   8.8 Twist alpha
   8.9 Roughness
   8.10 Solderability
   8.11 Edge stress
   8.12 Electrical resistivity or conductivity test
   8.13 Retests
   8.14 Rounding of results
9 Declaration of conformity and inspection documentation
   9.1 Declaration of conformity
   9.2 Inspection documentation
10 Marking, packaging, labelling
Tables
Annex A (informative) Physical properties
Annex B (informative) Bibliography
Annex C (normative) Lead fatigue test

Defines the composition, property requirements and tolerances on dimensions and form for copper and copper alloy strip for lead frame material, with widths up to and including 100 mm. Thicknesses between 0.1 mm up to and including 1.0 mm are generally used for stamped lead frames for integrated circuits and low power devices and thicknesses from 1.0 mm up to and including 2.0 mm are generally used for stamped lead frames for high power devices.