I.S. EN 19:2016
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
INDUSTRIAL VALVES - MARKING OF METALLIC VALVES
Hardcopy , PDF
English
01-01-2016
16-11-2023
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
National Foreword
European foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
5 Details of markings
Annex ZA (informative) - Relationship between this European
Standard and the essential requirements of Directive
2014/68/EU (Pressure Equipment Directive) aimed
to be covered
Defines the requirements for marking of industrial metallic valves. Also defines the method of applying the markings, on the body, on a flange, on an identification plate or any other location.
| DocumentType |
Standard
|
| Pages |
16
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| BS EN 19:2016 | Identical |
| DIN EN 19:2016-07 | Identical |
| EN 19:2016 | Identical |
| NEN EN 19 : 2016 | Identical |
| NS EN 19 : 1992 | Identical |
| ONORM EN 19 : 2016 | Identical |
| UNE-EN 19:2016 | Identical |
| EN 12516-1:2014 | Industrial valves - Shell design strength - Part 1: Tabulation method for steel valve shells |
| EN 12516-4:2014 | Industrial valves - Shell design strength - Part 4: Calculation method for valve shells manufactured in metallic materials other than steel |
| EN 736-2:2016 | Valves - Terminology - Part 2: Definition of components of valves |
| ASME B1.20.1 : 2013(R2018) | PIPE THREADS, GENERAL PURPOSE (INCH) |
| ISO 7-1:1994 | Pipe threads where pressure-tight joints are made on the threads — Part 1: Dimensions, tolerances and designation |
| ISO 228-1:2000 | Pipe threads where pressure-tight joints are not made on the threads — Part 1: Dimensions, tolerances and designation |
| EN 736-3:2008 | Valves - Terminology - Part 3: Definition of terms |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.